DIEBOLD G1-912N Manuel de l'utilisateur

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} DIEBOLD G1-912N. DIEBOLD G1-912N 2 pages. Private container with lcd and electronic combination lock

Imprimer la page

User＇ s Manual for Private Container with LCD and Electronic Combination Lock

Please read this User＇ s Manual carefully before using this product. Its factory code is: 1、5、9.

Open the door of the private container (See ＂Using the Override Key＂in Page 2). Take out the 4AA batteries

from the Private Container, and install it in its compartment. (See＂To Replace the Batteries＂in Page 2.)

Enter the code followed by pressing the＂　＃　＂ button and the prompt ＂　　　　

screen. Within 5 seconds, turn the knob clockwise

Note: The factory code 1、5、9 should be used to open the door of the Private Container for the first

time. Please program your new user code after the first operation. Refer to ＂To Program Your

User Code＂for details.

The interval between two pressing button should not exceed 20 seconds, otherwise this operation

will become invalid.

Close the door of Private Container, then turn the knob counterclockwise

Locate the battery compartment in the door back. Remove its cover according to Figure A. Press the user code

changing button. The prompt ＂　　　　　　

is in process of changing the user code. (Please replace the battery compartment cover after completion of

changing the user code.)

With the door open, enter your new user code (2-8 digits) followed by pressing ＂　＃　＂ button. The LCD screen

will flash your new user code three times and turn off by itself.

New user code has been successfully set up.

Note: Please repeat operating the Private Container

with your new user code according to ＂To

Open＂for several times to confirm that your

new user code can open the door. Then close

the door and turn knob counterclockwise

Please keep your new user code in a safe place

as the old code becomes invalid now.

Turn the LCD disk board counterclockwise

override keyhole behind the disk board. Insert the override key (See Figure C) into the hole and turn it clockwise

followed by turning the knob clockwise

Knob

LCD Disk Board

Figure B

Applies to Model JJB-23L1

F i r s t T i m e O p e r a t i o n

T o O p e n

T o C l o s e

T o P r o g r a m Y o u r U s e r C o d e

＂will be displayed on the LCD screen with two beeps to indicate that it

User Code Changing Button

U s i n g t h e O v e r r i d e K e y

and remove it from the panel (See Figure B). You will see the

to open the door of Private Container.

＊

＃

Figure C

Override Keyhole

Shanghai Diebold Security Equipment Co., Ltd.

Add. : 1188 Caobao Rd., Shanghai, 201102, P.R. China

Tel : 86-21-6480 1118

Website: http:// www.diebold.cn

B-23L1 B-23L1-1

G1-912N、G1-913N and JJB-23L1-1

to open the door of Private Container.

(Please remove the override key in time after operation.)

Note: The override keys are for

＂ will be displayed on the LCD

, and the door will be locked.

Compartment Cover Moving Direction

Figure A

emergency use. Please keep

them in a safe place. Do not

place them in this Private

Container.

Fax : 86-21-6480 1238