Alpha Professional Tools AIR-680 Manuel d'instruction - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Alpha Professional Tools AIR-680. Alpha Professional Tools AIR-680 20 pages. Pneumatic polisher
Également pour Alpha Professional Tools AIR-680 : Manuel d'instruction (20 pages)

Imprimer la page

PolIshING ANd usING The Tool

This tool and the Alpha

are designed to be used under light downward hand pressure. You

need to allow the polishing pads, core bits, and profilers to do their

job. Applying excessive downward pressure to the tool will cause the

vanes to wear out in the middle and fail prematurely.

sPINdle sIZe

The Alpha

AIR-680 air polisher features a 5/8"-11 spindle. This tool

has been designed for portable/shop production and uses all modern

accessories. It is very important that you do not run anything heavier

than the recommended accessories on this machine. A drop of oil

should be applied to the outside threads whenever attachments are

changed to facilitate removal and prevent rust. A Double End Wrench

(19mm/22mm) is provided to assist in changing accessories.

maintenance and usage Tip:

• Do not leave the tool submersed in water. This could expose

the inner moving parts to moisture, which will shorten the life

of the tool.

• Do not leave threaded accessories (backer pads, core drill

bits, profilers) on the spindle of tool for extended periods of

time; this may result in making it difficult to remove these

accessories.

• Excessive force or impact to the spindle may result in

premature failure of gears, keyways and bearings, which may

not be immediately evident.

AIR VAlVe leVeR

The valve lever controls the flow of air

through the tool. It has two positions- ON

or OFF. Run the tool at the recommended

pressure of 85 PSI, with the lever

pointing to the ON position. This will

produce 4,000 RPM. Do not try to vary

the speed. The tool works best at full

accessories approved for use with this tool

CAUTION!