Epever BTBLANKET180 Manuel - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Epever BTBLANKET180. Epever BTBLANKET180 4 pages.

Imprimer la page

How to connect the blanket to your devices

Now with a new Anderson connector - the 180w Baintuff solar blanket offers a simple

plug and play solution. The blanket comes with an Anderson cable and a Solar

Controller. The Solar Controller is normally used when there is no internal controller in

your equipment. (ie: when you want to charge your car battery, or a secondary battery

in a trailer.)

DC18V OUTPUT

Connect the Anderson connector with solar charger controller and then connect the

Alligator clamps to your batteries. Always connect the battery you are wanting to

charge FIRST to the Solar Controller before connecting the Solar Blanket. The reason

is the Controller's AUTO SENSING needs to know what voltage it has to be set at,

before the Controller can operate.

USING WITH THE BAINTECH POWERTOP

The grey Anderson connector on the Solar Controller is plugged into the Powertop's

grey Anderson socket or the battery you are intending to charge. The red Anderson

socket is plugged into the cable from the blanket with the same. Plugging the grey

connector in first, allows the auto-select function to kick in and determined if the battery

is 12 or 24 volts before the blanket is connected.

SOLAR REGULATOR INCLUDED - See product specifications

Visit www.baintech.com.au to find out more

Warning and Safety Instructions

Do not drive over the blanket, leave in wet environments - such as rain or sea water,

or unattended where wind and theft may occur. If wind is likely to be an issue, use

the supplied holes around the edge to tie down or peg the blanket to a secure spot.

1. Risk of explosive gases: working in the vicinity of a lead-acid battery is dangerous.

Batteries generate explosive gases during normal operation. For this reason, it is of

utmost importance that you follow the instructions each time you use the solar panel

charger.

2. Solar panel charger should not be used by persons with reduced physical, sensory

or mental capabilities unless they are supervised by a person responsible for their

safety.

3. Do not charge non-rechargeable batteries by the solar panel charger. It can

damage the regulator or solar panel charger or create harm for the operator. Only

use the solar panel charger DC18V for charging standard lead-acid, lithium-polymer,

Li-Fe, Gel and AGM type 12V batteries .

4. Never smoke or allow a spark or flame in vicinity of battery or engine. This may

cause the battery to explode.

5. Please keep the junction box out of water, if there is some water in the junction

box, please make sure it's dry before using. Always clean the blanket after use to

keep cells efficient and at their maximum.

ADD ON SOLAR ACCESSORIES

ADD ON:

Baintech Watt Meter

BTWATT01

Take the guesswork out of how

much power your solar panels are

generating. The Baintech Watt

meter once connected will give

you real time information on:

• Current (Amps/A)

• Voltage (Volts/V)

• Power (Watts/W)

Baintech PowerTop V3

BTPTOP135V3

Ready to go right off the shelf, this

fully portable plug-and-play system

features a 12V 135Ah AGM

battery with charging inputs for AC,

DC and solar.