Olympus BH2-CH Substage Assembly - Page 14

Parcourez en ligne ou téléchargez le pdf Assembly pour {nom_de_la_catégorie} Olympus BH2-CH Substage. Olympus BH2-CH Substage 26 pages.

Figure 40 – Tighten the plunger-retaining screw

Figure 41 – Head of retaining screw must be recessed

Reinstall the Condenser-Height Rack

Clean any grease from the bevels and from the face of

the dovetail slide, and reinstall the brass shim for the

condenser-height rack onto the face of the dovetail

slide (see

Figure

42). Use a few spots of heavy grease

behind the brass shim to hold the shim in position for

the subsequent reassembly steps, if necessary.

Figure 42 – Reinstall brass shim for condenser-height rack

Clean any grease or debris from the condenser-height

rack. Use a suitable JIS screwdriver to loosely reinstall

the two M2.6x6 JIS screws and two washers to hold the

rack in position on the dovetail slide (see

Complete Teardown, Cleaning/Lubrication, and Reassembly of the Olympus BH2-CH Substage Assembly

Figure 43 – Reinstall screws for the condenser-height rack

Tighten the two M2.6x6 JIS screws to secure the

condenser-height rack to the dovetail slide (see

44). Do not over-tighten these screws or the plastic

rack may be damaged.

Figure 44 – Tighten screws for the condenser-height rack

Clean any old grease from the slip plates, centering

yoke, and support yoke (see

Figure 45 – Parts for the condenser-centering mechanism

Lightly grease the lower bearing surface of the

centering yoke (see

Figure

43).

Figure

45).

Figure

46).

Revision 1

Page 14 of 26

Figure