Olympus BX43 Manuel d'instructions - Page 18

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} Olympus BX43. Olympus BX43 48 pages. System microscope

Fig. 13

Fig. 14

Fig. 15

Using the Filters (Halogen Bulb Operation Only)

} You can place a filter in the light path with either method.

· Place a filter on the filter mount on the base and engage in the light path.

(Page 14)

· Insert a filter in the U-FC filter cassette, attach it on the filter mount and

engage it in the light path by sliding the filter level. (Page 14)

Mounting a Single Filter (Fig. 13)

A filter with a diameter of 45 mm can be placed on the filter mount on

the base. If you need to place multiple filters, please purchase the U-FC

filter cassette.

Even when a filter cassette is used, a filter with thickness of no

CAUTION

more than 3 mm can still be placed on the filter mount.

Using the Filter Cassette (Figs. 14 to 17)

Loading Filters into Filter Cassette

} The filter cassette accommodates filters with a diameter of 45 mm and

thickness of 2.7 mm or less.

} The filter cassette has two filter levels on the right side and one on the

left side.

} When the filter cassette is used, the ECO mode cannot be used because

the human sensor is hidden by the filter cassette.

1. Move all filter levers to the OUT position except for the one belonging to

the slot into which the filter is to be inserted.

2. Slide lever @ to the IN position. Make sure that it clicks securely into

place. (Fig. 14)

3. Holding the lever in the position shown in Fig. 14, put the filter into the

cassette by inserting it in the direction indicated by the arrow.

4. Insert the other two filters in the same manner.

Mounting the Filter Cassette

1. Fully loosen the filter cassette clamping screw 2. (Fig. 15)

2. Align the key 3 on the bottom surface of the filter cassette with the

positioning slot | on the filter mount, then snap the filter cassette into

place from above.

3. Rotate the filter cassette to align its sides with the base. (Fig. 16)

4. Align the clamping screw 2 with the positioning hole 5 on the filter

mount, then tighten the screw to fasten the filter cassette.

When the filter cassette is installed, the condenser may hit it

CAUTION

when the stage is lowered. Therefore, exercise caution when

lowering the stage with the filter cassette installed.