Olympus BX51 Manuel d'utilisation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Olympus BX51. Olympus BX51 17 pages. System
Également pour Olympus BX51 : Manuel d'instructions (40 pages), Manuel d'instructions (34 pages), Manuel d'instructions (37 pages), Manuel d'utilisation (11 pages)

FLUORESCENCE

1. Remove the microscope cover.

2. To turn on the mercury bulb, set the main switch (18) on the Power Supply Unit to "I"(ON).

The light indicator (19) on the Power Supply Unit should go ON. Wait 5 to 10 minutes for

the mercury bulb to stabilize. The mercury bulb should stay on for at least 15 minutes before

turning off.

3. Setup microscope for brightfield imaging (see instructions on 'Brightfield' page 1, # 2-12).

4. Engage the fluorescence mirror unit (17) until the proper filter cubeì is in place:

5. Turn the light intensity down all the way using the brightness adjustment knob (3).

6. To allow light from the mercury bulb to reach the specimen, slide the shutter knob (20) to

position marked ™.

7. To improve image contrast and to prevent color fading of fluorescent light in other part than

observed region, pull out the field iris diaphragm knob (21) so that the image of the field iris

diaphragm just circumscribes the field of view.

8. To help adjusting the brightness of you the observed image and to improve the contrast, pull

out the aperture iris diaphragm knob (22), the aperture iris diaphragm will get smaller.

9. Examine specimen and document image if necessary:

10. To avoid bleaching, slide the shutter knob (20) to the position marked ˜ whenever you are

not observing the specimen.

11. When finished:

This Manual: http://www.manuallib.com/file/2605418

WU – #1, dichroic mirror DM400, excitation filter BP330-385, barrier filter BA420

WB – #2, dichroic mirror DM500, excitation filter BP450-480, barrier filter BA515

WG – #3, dichroic mirror DM570, excitation filter BP510-550, barrier filter BA590

If using 35mm film, use checklist for 'Olympus 35mm Camera'.

To obtain still digitized images, use checklist for 'Polaroid Digital Microscope

Camera (DMC).

To obtain still digitized images and digitized movies, use checklist for 'Sony, color

Video camera'.

Slide the shutter knob (20) to the position marked ˜.

If mercury bulb has burned for at least 15 minutes, turn off the mercury bulb by

setting the main switch (18) on the Power Supply Unit to "O"(OFF). The light

indicator (19) on the Power Supply Unit should go out.

NOTE: The mercury bulb needs to cool down for at least 15 minutes before turning

back on.

Lower the stage by turning the focus knob (10) towards you and remove the slide

with your specimen from the stage (7).

Turn the nosepiece (12) back until the 10x objective is into place.

If the100x objective was used, clean the lens carefully with lens paper ONLY (do

not use Kimwhipes).

Push the field iris diaphragm knob (21) and the aperture iris diaphragm knob (22) al

the way back into the microscope.

Engage the fluorescence mirror unit (17) back to BF (brightfield) - #6

Cover the microscope when the mercury bulb is cooled down (15 minutes after it was

turned off).

Leave the room CLEAN and TIDY!