Olympus E-PL1 Manuel de l'utilisateur - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Olympus E-PL1. Olympus E-PL1 9 pages. Camera underwater housing
Également pour Olympus E-PL1 : Spécifications (5 pages)

Imprimer la page

After replacing and locking the lid, make a final visual inspection of the main O-ring for

contamination.

Note: If the O-ring is in good contact, a thin black line, about 0.5 to 1mm in width should be

visible, where the O-ring is in contact with the lid. Follow this line all the way round the

edge of the seal, as a final check that the seal is good.

The housing is now ready for the dive.

5. Use & Care of Housing

5.1 Pre Dive Function Check.

Just before entering the water, make a habit of reviewing that you have carried out the proper

steps to close the housing and the bulkhead is connected. Make a visual check of the O-ring seal.

It is also useful to switch on the camera, and check that controls e.g. on/off, zoom, shutter

functions operate normally.

Check housing is closed

Check O-ring is in the groove between housing and Acrylic

Check battery and memory card status on the LCD display

Check the shutter release, control knobs and zoom function.

Always avoid submerging the housing in hot water for a prolonged time or a cleansing

tank where the water may be heated up by the sun.

5.2 General Operation.

The control levers and push buttons consist of internal double O-ring seals on a stainless steel

shaft. This arrangement is very reliable, however as a precaution, when operating the controls,

avoid excessively rapid movements, as this may distort the O-ring. Also please allow for the fact

that the camera takes a while to power on. If the camera dose not appear to respond to a control

action, make sure that no other controls are pressing on the camera, i.e. locking out further

actions.