Olympus PT-030 Manuel d'instruction - Page 15
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Olympus PT-030. Olympus PT-030 44 pages. Underwater case
Imprimer la page
Removing the TTL cable connector cap
TTL cable
connector cap
① Turn counter clockwise.
1
2
③Insert into the
connector.
---- How to attach the TTL cable connector cap to the case ----
Make sure there is no foreign matter attached to the O-rings inside the cap and on
the TTL cable connector. To secure the cap, gently turn it clockwise until it stops.
Cap
Check O-rings
CAUTION
: • If the TTL cable connector cap is loose, water
penetration may result. Be sure to gently turn the cap
until it stops to make sure it is firmly secured.
Do not turn or tighten the TTL cable too hard. If it is too
tight, it may be difficult to loosen and remove it.
❈ For details on the TTL cable and hot shoe cable, refer to the
instruction manual provided with the Electronic Flash Case.
② Remove.
1Remove the TTL cable connector
2Connect the Electronic Flash
Underwater
TTL cable
Use this mark to
align the position.
Connector
E-14
To perform TTL flash shooting in
combination with the separately
available Electronic Flash Case,
remove the TTL cable connector
cap as described below.
cap from the Case.
Case's underwater TTL cable to
the TTL connector on the Case.
④ Turn the threaded section of the connector
clockwise lightly until it is stopped.
② Gently turn the cap
clockwise until it stops.
①
Put the cap
on the case.