Olympus PT-034 Manuel d'instruction - Page 33

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Olympus PT-034. Olympus PT-034 44 pages. For the digital camera stylus 750/740, µ 750/740

Imprimer la page

Install the O-ring.

Confirm that no foreign matter is attached, apply a thin coat of the

accessory grease to the O-ring, and fit the O-ring into the groove. At

this time, confirm that the O-ring does not stick out from the groove.

How to Apply Grease to the O-ring

Apply the

exclusive

lubricant to each

O-ring.

Spread the

lubricant all over

the O-ring.

Check that the

O-ring is free of

scratch or

unevenness.

Apply lubricant on

the O-ring contact

surface.

CAUTION

: • Always perform maintenance of the waterproof

function even when the Case has been opened to

exchange the battery or the image storage during

shooting. Neglecting this maintenance may become

the cause of water leakage.

• When the Case is not to be used for a long time,

remove the O-ring from the groove to prevent

deformation of the O-ring, apply a thin coat of silicone

grease, and store it in a clean plastic bag or the like.

• When drying is done with salt attached, it is likely that

a function impairment will be caused. After use,

always wash off any salt.

Make sure that your fingers and the O-

ring are free of dirt, and squeeze about

5 mm of lubricant onto a finger. (5 mm

is the most appropriate amount.)

Surround the lubricant with three

fingers and spread it over the ring. Be

careful not to use excessive force as

this may stretch the O-ring.

After spreading the lubricant, check

visually and by touch that the O-ring is not

scratched and that its surface is flat. If it is

damaged in any way, replace it with a

brand-new O-ring.

Use the lubricant remaining on the

fingers to clean and lubricate the

case's contact surface.

E-32