Olympus U-LLGAD Manuel d'instruction - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Olympus U-LLGAD. Olympus U-LLGAD 20 pages. Light guide illumination system

Imprimer la page

IMPORTANT

This light source unit is the fluorescence illumination light source which does not need to adjust

centering. By combining with the microscope, uneven stable illumination can be provided.

SAFETY PRECAUTIONS

Do not turn on the lamp without attaching liquid light guide and liquid light guide adapter to the microscope. The

UV light is included in the lights from this lamp. Looking directly into the light may damage your eyes. Also, it could

cause fire.

Before replacing the lamp, be sure to set the power switch to \ (OFF), unplug the power cord from the outlet, and

wait until the lamp replacement cover and the lamp have cooled down completely (more than 40 minutes as a

guide) to avoid electric shock or burn.

Install the light source unit on a sturdy, level table or bench.

Install this equipment on a flat surface which does not block the ventilation opening on the bottom panel. Do not

place it on a soft surface, e.g. paper or cloth, etc. This could cause fire.

Make sure to leave sufficient space for ventilation around this equipment. Never allow metallic objects to enter the

ventilation opening. This could cause fire or electric shock.

When installing this equipment, secure sufficient space larger than 10 cm around this equipment to release the

heat.

In order to prevent the liquid light guide from being broken, the bend radius of the liquid light guide must be larger

than 40 mm.

Always use the power cord provided by Olympus. If no power cord is provided, please select a proper power cord

by referring to the section "PROPER SELECTION OF THE POWER CORD" at the end of this instruction manual. If the

proper power cord is not used, product safety performance cannot be warranted. Place the power cord far enough

from the heat source so that it does not touch it, e.g. near the lamp replacement cover, etc.

Do not turn ON the light while the lamp replacement cover is open. Doing so could result in electric shock, burn,

light source unit failure or deterioration of the light guide.

10) Be sure to connect the power cord to a grounded outlet. Otherwise Olympus cannot warrant the intended electric

safety and performance of this equipment.

11) Never touch the power plug during a thunder-storm.

12) The light source must be located/installed in such a way that there is easy access to the AC inlet located on the

rear of the equipment as the AC inlet is designated as the main disconnecting device for this equipment.

Safety Symbols

The following symbols are on the unit. Study the meaning of the symbols and always use the equipment in the safest

possible manner.

Symbol

Indicates the presence of high voltage. Take caution to guard against electric shock.

Indicates that the surface becomes hot, and should not be touched with bare hands.

Indicates a non-specific general hazard. Follow the description given after this symbol or in

instruction manual.

Indicates that the main switch is ON.

Indicates that the main switch is OFF.

Caution

If the system is used in a manner not specified by this manual, the safety of the user may be imperiled. In addition, the

equipment may also be damaged. Always use the equipment as outlined in this instruction manual.

The following symbols are used to set off text in this instruction manual.

: Indicates a potentially hazardous situation which, if not avoided, may result in minor or

CAUTION

moderate injury or damage to the equipment or other property. It may also be used to alert

against unsafe practices.

}

: Indicates commentary (for ease of operation and maintenance).

Explanation

U-HGLGPS