Axley 013759 Manuel d'utilisation - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Axley 013759. Axley 013759 10 pages. Pop-up tent

Imprimer la page
EN

SAFETY INSTRUCTIONS

•
Do not use the product in strong wind.
•
Do not use product near strong chemicals or a naked flame.
ASSEMBLY
NOTE:
Follow these instructions carefully – risk of pinch injury. At least
two adults are needed for assembly.
1.
Place the product in the middle of the area to be covered.
Remove the storage bag and put the folded product on its
feet. Before moving the product, check that none of the roof
stays have fastened.
FIG.
1
2.
Stand on each side of the product and take hold of the two
outer legs. Lift the frame a little and take one short step
back. Do not pull too hard backwards, this could bend the
side stays.
FIG.
2
3.
Press the top and bottom edges of the square formed by
the side stays together. Repeat on the opposite corners and
take small steps back each time, until the product is almost
completely unfolded.
FIG.
3
4.
Hold down the top part of the leg with one hand and bring
up the locking sleeve with the other hand until it engages.
The button should engage in the lock hole. Repeat for the
other three legs.
FIG.
4
FIG.
5
5.
Place the tent fabric over the frame. Fasten the velcro straps
on the underside of the roof, around the frames.
FIG.
6
6.
Put one foot each on the footplate at the bottom of two
adjacent legs, then pull up so that the inner part of the leg is
pulled out and the button engages in the lock hole. Repeat
for the other two legs.
FIG.
7
7.
Adjust the product.
FIG.
8
8.
Secure the product by anchoring the guys, which sit in rings on
the corners of the roof, with tent pegs. Alternatively the tent
pegs can be stuck in the ground through holes in the feet.
FIG.
9
FOLDING
1.
Release the guys and anchors and remove the velcro straps
on the roof from the frame.
FIG.
10
10
2.
Lift two adjacent legs a little on each side, press the button
and lower the inner part of the leg into the outer part.
Repeat for the other two legs.
FIG.
11
3.
Release the locking sleeves in the four corners by pressing
gently up with one hand and pressing the button with the
other. Lower the locking sleeve so that the button is free.
FIG.
12
FIG.
13
4.
Grip the square that is formed by the stays on each side
and lift a little. Shake the roof of the tent a little. Move your
hands apart and move towards each other until the tent is
three-quarters folded.
FIG.
14
5.
Grip the two outer legs, lift a little and press the product
together.
FIG.
15
6.
Check that the tent fabric is completely dry. Fold up the
product and put it in the storage bag.

MAINTENANCE AND CLEANING

•
Clean the tent fabric with soapy water and rinse well.
•
Allow the tent fabric to dry before putting it away.
•
Wipe the legs with a damp cloth.