Axminster 100714 Manuel de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Axminster 100714. Axminster 100714 8 pages. Single hinge jig

Imprimer la page

Fig 04

Guide bush and cutter

4. When setting the recess depth (i.e. cutter depth), sit

the router flat on the template face and bottom the

cutter on to the door edge. (See fig 05) Set the depth

stop using the flap of the hinge inserted between

the turret stop screw and the depth gauge rod. It is

always advisable to initially cut the recess in a piece

of scrap timber and check the finished recess depth.

Fig 05-06

Setting the recess for the cutter depth

The door edge

Cutting the door hinge by starting

from the door edge

5. Cut the recess by first locking the router plunge

to the depth set by the depth gauge and cutting

in from the edge of the door. (See fig 06) Start by

making a back cut (i.e. against the direction of cutter

rotation, that is from right to left), before removing

the remaining waste from the recess. By back cutting

you will achieve a clean recess edge. If the recess is

slightly short, remove a sliver from one end using a

sharp bevel edge chisel.

6. To finish, square the corners of the recess using a

corner chisel (code 340437) or a sharp bevel edge

chisel. (See figs 07-08)

Using the Template

Fig 07-08

Corner chisel

Bevel edge chisel

Door hinge recess