Axminster 106382 Manuel d'instructions original - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions original pour {nom_de_la_catégorie} Axminster 106382. Axminster 106382 8 pages.

Using the Template

7. Matching recesses can be cut into doorframes or linings

using the hinge jig. The jig can be clamped to the frame

prior to the architraves being fitted or to a lining prior to

the architraves and planted stop being fitted, see fig 09.

Countersunk screw holes are provided on the template to

provide extra support if necessary, or for use when a clamp

cannot be fitted. To provide extra support when recessing

a frame with a machined stop, attach a small block of

wood, the same depth as the stop, to the underside of the

template with double-sided tape.

To cut the recess, align the template against a hinge centre

line drawn on the frame or lining and cut and finish as for

the door edge, see fig 10.

Fig 09

The jig being clamped to the frame prior to the

architraves being fitted or to a lining prior to the

architraves and planted stop being fitted

Fig 10

To cut the recess, align the template against a hinge

centre line drawn on the frame or lining and cut and

finish as for the door edge

8. When cutting a number of doors with similar hinge

positions, two or more templates can be used, fitted to a

24mm by 24mm timber batten and spaced out accordingly.

Concealed cabinet hinges

9. The hinge template can also be used to bore circular

holes to accept the boss of a concealed cabinet hinge, the

standard diameter hinge bosses being 35 and 26mm.

Again using various guide bush and cutter diameters will

accommodate different hinge boss diameters. The template

hole is 48mm diameter, therefore a combination of a 24mm

guide bush and a 12mm cutter and a 30mm guide bush

and 9mm cutter will produce recesses of 35 and 26mm

diameter respectively.

In use, simply set the box section on the template to posi-

tion the hinge in from the edge of the door. Mark the centre

line of the hinge from either top or bottom door edges.

Align the template centre line and clamp the template

securely, see fig 11. Set the cutter depth to the depth of

the hinge boss (normally 10mm) plus the thickness of the

template.

Fig 11

Template hole

Fig 12

Cabinet hinge