Axminster Router Elevator 210081 Manuel de l'utilisateur - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Axminster Router Elevator 210081. Axminster Router Elevator 210081 16 pages.
Fitting the Accessory Digital Readout Scale...
Fig 7a
Clamping plate
Fig 8
If the DRO is masked/shielded/awkwardly sighted when the assembly is mounted in your
installation, you may wish to consider the addition of the Single Axis Remote Reader
(210068) whereby you can place the relayed digital readout where it is most convenient.
The router elevator requires minimum maintenance, but you are advised to observe the
following points:-.
1. Keep the elevator clean. Ensure that dust/chips etc., are cleaned away at the end of a
work session.
2. Do not allow a build up of dust/chips etc., between the machine table and the rise and
fall platform, or under the machine, where it may foul the chain drive.
3. If the winding action becomes 'lumpy' check that there is no debris caught in the chain,
or compressed onto a sprocket.
4. Check the chain tension. If the chain has become 'slack' or loosened, re-tension by
adjusting the idler sprocket. Do not over tension, the chain needs to be firm, with a small
side to side movement (best checked on a 'long' side): it does not need to be rigid.
5. Remember! A chain is a machine as well, give it a light lube.
Mounting plate
Fitting the
clamping plate
Attachment
bracket
Screws
Fig 7
Data output port to
connect the Single
Axis Remote Reader
Fig 9
Maintenance...
13