Axminster 109540 Manuel d'instructions original - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions original pour {nom_de_la_catégorie} Axminster 109540. Axminster 109540 6 pages. Drill press table

Imprimer la page

▲Use personal protective equipment. Always wear eye protection. Protective equipment such as a

respiratory mask, non-skid safety shoes and hearing protection used for appropriate conditions will

reduce the risk of personal injury.

▲Prevent unintentional starting. Ensure the switch is in the off-position before connecting to power

source and/or battery pack, picking up or carrying the tool.

▲Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left

attached to a rotating part of the power tool may result in personal injury.

2.3 ELECTRICAL SAFETY

▲Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any adapter

plugs with earthed (grounded) power tools. Unmodified plugs and matching outlets will reduce risk of

electric shock.

▲Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and

refrigerators. There is an increased risk of electric shock if your body is earthed or grounded.

▲Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the

risk of electric shock.

▲Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep

cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk

of electric shock.

▲When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a

cord suitable for outdoor use reduces the risk of electric shock.

3. ASSEMBLY & ADJUSTMENTS

3.1 INSTALLATION ON TABLES WITH THROUGH SLOTS

1. Slide the heads of the M8x90 bolts (part 1) into the

back T-track (part 2), one on each side, and slide one into

the front T-track (part 3), if desired.

2. Position the bolts in the back T-track such that they fit

through the slots on the metal drill press table. Place them

through the slots. Position the table so that the front bolt is

lined up with the front of the table, or passes through a slot or

hole in the metal table, depending on your drill press model.

NOTE: When installing the drill press table onto

the drill press, make sure that the narrow end is

against the drill press column as shown. This

will allow room for the handle to rotate freely.