Axminster MD150Q Manuel de l'utilisateur - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Axminster MD150Q. Axminster MD150Q 16 pages. 150/200mm wetstone grinder
Également pour Axminster MD150Q : Manuel de l'utilisateur (20 pages)

Imprimer la page

Setting up the Grinder...

A X M I N S T E R

W H I T E

Please read the section entitled Identification and Description of Parts, in order for

you to understand the terminology that we will use, so that you may better

understand the working and capability of your grinder. Keep this manual to hand for

reference for any other personnel that may be required to use the grinder.

Having assembled all the grinder attachments loosely, now the machine has to be set up

correctly and all the attachments securely fastened.

Place the grinder on a flat level surface.

Position the tool rest leaving a gap of approximately one and a half millimetres between the

grindstone and the rest, with the rest horizontal (preferably) tighten the star nut securely.

(See fig 4)

Remember to adjust the tool rest as the grindstone wears down.

Adjust the spark guard until it is just clear of the grindstone; fasten the fixing bolt securely.

(See fig 5)

Remember to adjust the spark guard as the grindstone wears down.

Fig 4

Star nut

Adjust the spark guard until it is

just clear of the grindstone

Position the eye shield on its pivot bolt, (if necessary, 'nip' the clamping bolt of the eye

shield clamp so that the eye shield remains in place).

If there is any tendency for the grinder to move, tip or tilt while it is being operated, it should

be bolted down; either to the bench or to a specific stand or base board.

It is a good idea to dress new grindstones before use, to remove any possible irregularities,

and ensure the stones are running concentrically.

www.axminster.co.uk

Leave a gap of approximately

one and a half millimetres

between the grindstone

and the rest

Fig 5