Axminster MD200Q Manuel de l'utilisateur - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Axminster MD200Q. Axminster MD200Q 16 pages. 150/200mm wetstone grinder
Également pour Axminster MD200Q : Manuel de l'utilisateur (20 pages)

Identification and Description of the Grinder...

W
A X M I N S T E R
W H I T E
Grinding
machine
Wheel guard
Tool rest
Eye shield/
spark guard
Gearbox
Water trough
ON/OFF switch
Hold down holes Four 8mm holes set in a matrix in the corner flanges of the chassis to
10
Essentially a double ended motor, with a mounting base, the motor
flanges mount the wheel guard at the dry stone end and the transition
gearbox at the wet stone end. The motor base contains the On/Off NVR
switch.
A formed metal guard that encloses the grinding wheel. It is formed in
three parts. The inner part is mounted onto the motor flange, The stone
cover is 'sprung' into the lip of the inner part and the outer part is
located on it. The whole assembly is bolted together. There are various
'hard point locations' that accept the fixing bolts that secure the
attachments of the machine.
Formed metal plate that bolts onto a hard point on the inside cover of
the wheel guard. There is an elongated slot in the rest which gives
adjustment along the coach bolt fixing.
Clear protective shield that mounts over the grindstone to afford a
view of the workpiece, but offer protection for the eyes; it is mounted
onto the spark guard making a complete assembly that bolts through a
hard point on the upper part of the stone cover. The spark guard itself
has an elongated slot to allow positioning and adjustment as the wheel
diameter decreases. Its' function is to contain any material (esp.sparks)
that would be tracked around the grindstone and sprayed out of the
machine esp. over the hands.
A transition (through 90˚) gearbox that is mounted onto the end flange
of the motor. The gearbox reduces the speed of the wet stone to approx.
120 rpm.
A moulded plastic trough that is screwed to the o/p face of the gearbox.
During operation the trough is filled with water, and the stone runs
partially immersed., This self dousing action maintains the 'cold
temperature' of the stone and helps to remove the grinding waste from
the face of the stone. There are a number of preformed notches in the
lip of the trough that can be used to rest/steady objects being offered
up to the stone. (See page 11) There is a shaped rubber plug, which
also acts as a stabilising support for the grinder as well as blocking the
drain hole. (See fig 3)
A NVR double button switch panel, marked 'I' for On and 'O' for Off. The
NVR function ensures the machine will not be left in the 'ON' condition,
in the event of a power failure, and subsequent re-establishment of the
supply.
enable the grinder to be bolted down to the bench or a stand.
www.axminster.co.uk