Alphard Golf USA eWheels Club Booster Manuel du propriétaire - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Alphard Golf USA eWheels Club Booster. Alphard Golf USA eWheels Club Booster 18 pages.
Imprimer la page
- 1. Table of Contents
- 2. Installing the Axle Clamp [Brackets]
- 3. Adjusting the Wheelbase
- 4. Charging the Battery
- 5. Setting up before the Round
- 6. Severe Inclines
- 7. Controller: First Time Use
- 8. Controller: Speed Control
- 9. Controller: Steering
- 10. Controller: Distance Timer
- 11. Controller: Cruise Control
- 12. Controller: Electronic Brake Release
- 13. Controller: Pairing Your Remote with Club Booster
- 14. Warranty Information
- 15. Alphard Golf USA Contact Information
Adjusting the Wheelbase
The wheelbase (length between the wheels) can be adjusted to fit different cart frames. This procedure
is only necessary if there is a gap wider than 1" on the outside of both Axle Clamps when they are placed
on the Club Booster Axle. Most 3-wheel carts have a wider wheelbase than 4-wheel carts.
Adjusting the Wheelbase:
Step 1
Unfold your push cart. Measure the distance from the
outside edge of one Axle Clamp to the outside edge of the
other.
Measure
Step 2
Fully extend the wheels on the Club Booster. Rotate the
main body so the Console is facing downward and remove
the screws on the Stoppers.
Step 4
Slide the wheels inward until the distance between the tube
ends matches the distance you measured.
Step 5
Slide each wheel outward until the holes on the tube align
with the hole on the Stopper.
Step 6
Fasten the screw tightly again.
8