Alphasmart 3000 Instructions de montage - Page 3

Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} Alphasmart 3000. Alphasmart 3000 4 pages.
Également pour Alphasmart 3000 : Manuel de démarrage rapide (13 pages), Manuel rapide (3 pages)

Imprimer la page

use a ruler or other straightedge to make sure the switches are straight, as there is

no plate to align them.

Insert two of the stabilizer sliders into the bottoms of

two of the stabilizer housings, then insert the ends of

one of the stabilizer bars through the front of the

housings and into the lower holes of the sliders. Place

the bar snugly in the clip on the front of the housing.

Then insert the assembled stabilizer into the holes on

either side of one of the spacebar switches on the

front of the PCB so that the bar is towards the

Fig. 3

bottom and the split pegs are in the smaller holes

towards the top. Repeat all this for the other stabilizer.

Remove any batteries in the AlphaSmart. Undo the 8 screws on the back of the

AlphaSmart and carefully put them aside. Lift the front of the case and unplug the

display cable from the main board. Undo the 6 screws holding the original

keyboard to the case and put those aside as well. With tweezers or your nails, open

the latches on the connectors on the main board that the keyboard connects to and

remove the flex cables, then lift the keyboard out of the case. Carefully insert the

cables of the mechanical keyboard into the connectors on the main board and close

the latches. Place the mechanical keyboard so it fits over the two alignment pegs of

the case. Screw the screws back in, gently and evenly so as not to place undue stress

on the PCB. Because of the leads and switch pins sticking out of the underside of

the PCB, it will not be perfectly flush against the case. Plug the display cable back

in (the ribbon cable should run to the right) and screw the case back together. Place