Cineo LB800 Manuel de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Cineo LB800. Cineo LB800 19 pages. C2 os operating system

Power and Communications interfaces

Power Switch

DMX Thru

Power Input:

110-240 VAC

All connectors and system controls for the LB800 are located on the back of the unit. The touchscreen control display provides

access to menu selections, local control, effects/presets and remote-control options. Power connections and switch allow for easy

set up and strike. The DMX connections, RJ45 Ethernet port, embedded wireless receivers, RDM responders and powered USB port

support many options for external control.

Power Connector/Power Switch/Circuit Breaker

The LB800 unit is powered by an internal power supply, 110 – 220VAC via a locking PowerCon connector. Power is applied with the

switch above the connector. Maximum power draw is 900 watts. A self-resetting circuit breaker is located near the power

connection, which requires no user interaction. If the breaker trips, it will reset within one minute of tripping.

NOTES:

1. Ensure the power cable is disconnected before servicing.

2. Do not connect to a variable supply, such as a dimmer rack.

3. The power cable should be plugged into the power supply before switching the power ON. The power supply should be switched

OFF before removing the power cable.

Wired DMX Connections

LB800 uses industry-standard 5-Pin XLR male and female connectors to receive and pass-thru DMX signals and RDM signals. The

DMX port is self-terminating and does not require external DMX termination when used in a chain. If the unit is the last device on a

DMX chain, make sure that there is no cable inserted into the DMX Out connector.

The DMX pin wiring is as follows:

• Pin 1: Signal Common

• Pin 2: Data –

• Pin 3: Data +

• Pin 4: Spare

• Pin 5: Spare

RDM Support

The LB800 can remotely report unit information to an RDM controller via the RDM Identify command on either wired or wireless

DMX. The RDM information provided includes the model number (LB800), manufacturer's number (1A0D), followed by the last 8

vales from the wifi MAC address, which corresponds to the Unit ID.

Self-resetting

circuit breaker

Ethernet jack

DMX In

DMX Bridge port

USB Port

Touchscreen