ARC Appliances ADF6SEI Manuel d'installation et d'utilisation - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} ARC Appliances ADF6SEI. ARC Appliances ADF6SEI 18 pages.

Imprimer la page

Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent

cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to

facilitate proper installation.

Insert the drain hose into a drain pipe with a minimum diameter of 40 mm, or let it run into the sink, making sure to avoid bending

or crimping it. Use the special plastic support that attached with the appliance. The free end of the hose must be at a height

between 400 and 1000mm and must not be immersed in water.

DISHWASHER

Inlet pipe connector Drain pipe connector

FRONT VIEW

If the sink is 1000 higher from the floor, the excess water in hoses cannot

be drained directly into the sink. It will be necessary to drain excess

water from hoses into a bucket or suitable container that is held outside and lower

than the sink.

In order to avoid more water staying in the inlet hose,

please close the tap after using.(For the models: no safety inlet hose.)

Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is

fastened tightly in place.

If the water pipes are new or have not been used for an extended period of time, let the water

run to make sure that the water is clear and free of impurities. If this precaution is not taken,

there is a risk that the water inlet can get blocked and damage the appliance.

The water supply to the appliance can also be connected to the house hot water line

(centralized system, heating system),as long as it does not exceed a temperature of 60 C.

In this case, the wash cycle time will be shortened by about 15 minutes and the wash

efficiency slightly reduced.

The connection must be made to the hot water line following the same procedures as those

for the connection to the cold water line.

Once the appliance is positioned,adjust the feet (screwing them in or out) to adjust the

height of the dishwasher, making it level. In any case ,the appliance should not be inclined

more than 2 .

SINK

POWER OUTLET

Min 100mm