ARC Audio FD5000 Manuel d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} ARC Audio FD5000. ARC Audio FD5000 4 pages. Foose designs fd series

Imprimer la page

Please check the suitability of the installation

location before you begin. Do not cut any of the

car's structure. Pay attention to the mechanism of

the window and door.

If you do not have experience with automotive

electrical and mechanical systems contact a

professional installer. Paying a qualified installer is

almost always cheaper then paying a dealership to

repair your car.

THE INSTALL

Install the Woofer

After you have found the best location for the

woofer make or enlarge the mounting hole. Make

sure the opening is just large enough for the woofer

to fit tightly with no gaps. Make sure the surface is

flat and that the speaker does not bind up in the

opening. Use an awl or felt pen to mark the panel

and drill the screw holes without the speaker in

place. This will save the costly mistake of punching

a hole in one of your new speakers. Install the

woofer with the grill ring using the 4 screws

provided with this system. Firmly seat the grill into

its ring.

Remove the grill from the trim ring first then follow

the steps below installation.

1. Place the speaker in the opening with the

trim ring over it.

2. Screw the trim ring through the panel with

the clips beneath.

3. Install the grill into the trim ring. Add a few

drops of glue if necessary.

4. Snap in the finish ring.