Cino Micro2 Series Manuel de démarrage rapide - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cino Micro2 Series. Cino Micro2 Series 13 pages.

Verify Micro2 is Working

After fully charging the battery pack and loading the receipt roll, you can

print a configuration message to verify Micro2 is in proper working condition.

A configuration message will be printed after executing the self-test

procedure.

Steps:

1. Make sure the Micro2 is power off.

2. Press and hold the FEED Button and then press POWER Button.

3. Release both POWER and FEED buttons. The LED1-4 will flash 5 times

to indicate the battery status firstly, then the LED1 gives short orange

blinks 10 times. The Micro2 will start printing a configuration message.

4. Pull one edge of the receipt paper against the tear bar to tear the

configuration message down.

This message provides information on firmware version, communications,

power management, printer control setting, general specifications head

resistance and odometer.

Connecting the Printer Via Bluetooth

Please refer to the VersaJet Micro2 User's Guide on the Internet at

www.cino.com.tw for establishing Bluetooth connection.

Connecting the Printer Via RS232

1. Plug the connector of the RS232 cable into the Host Interface Connector

of the printer.

2. Power on the printer. The LED1-4 will flash 5 times to indicate the battery

status. Then the LED1 indicator will flash green at 2 seconds intervals.

3. The printer is now ready to print.

Host Interface Connector