Accurate Technology DigiStop-8 Manuel d'installation et d'utilisation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Accurate Technology DigiStop-8. Accurate Technology DigiStop-8 20 pages. Digi-stop series

Imprimer la page

ECTION

Mounting the Fence Assembly

1. Align the Fence Assembly adjacent to the saw

(Scale is to the rear of the fence).

2. Mark a line on the table top, along the front edge of

the Fence.

3. Remove the Fence assembly and mark a second line 7/8 inch (22mm)

behind the first line (this is the centerline of the Fence).

4. Drill mounting holes (at least 2) into the tabletop along the centerline of the

Fence.

5. Insert the supplied 10mm bolts

through the table from the top.

Install the supplied hex nuts onto

the bolts 1 or 2 threads deep at this

time.

6. Slide the Fence, end first, back into

place capturing the bolt heads in the

bottom T-slot of the Fence

Assembly. After the Fence is in

place and aligned to the saw,

tighten all nuts.

Install Stop Assembly

1. Carefully slide the encoder onto the Scale.

2. Loosen the locking knob and slide the Stop

assembly into the fence extrusion.

3. Position the encoder and Stop together and slide the

encoder under the Guide Clip so the post on the

encoder is captured in the slot of the Guide Clip, as

shown

4. Attach the readout to the aluminum block on the

stop using the extension bracket. Plug the encoder into the readout .

5. Move the stop assembly left to right and note if the readings increase or

decrease. Depending upon the installation (left or right infeed), it may be

necessary to reverse the reading direction.

See Section 3: Reverse Readings

Accurate Technology Digi-Stop

NSTALLATION

Page 7 of 20