Accurate Technology TWINSPIN REEL SR-30 L Manuel d'utilisation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Accurate Technology TWINSPIN REEL SR-30 L. Accurate Technology TWINSPIN REEL SR-30 L 12 pages. Twinspin reel
Également pour Accurate Technology TWINSPIN REEL SR-30 L : Manuel du propriétaire (5 pages)

Imprimer la page

OPERATION

Rubber

Washer

DRAG

VARIANCE

Basic operation of your

WIN

the spool is filled with line you can set the preset drag. First test the drag pressure with the preset tuned to a light drag

pressure (counter clockwise). Turn the preset clockwise until you reach your desired drag pressure. Standard

practice is to set the drag pressure at approximately 30% of your line strength. We have lasered lines around

the spool cover to give you a reference when turning the preset.

Make sure to keep the rubber washer on the preset well lubricated. If it is dry it will move with the spool when

line is pulled off the reel in drag mode.

Removing the Spool - Turn the preset lock counter-clockwise to remove the spool. Do not turn the preset

to remove the spool only turn the preset lock. Pull the spool off the spool shaft. When putting the spool back

Preset

onto the reel make sure to turn the spool slightly to align it with the cross pin on the spool shaft.

Lock

Reference

Marks

Thanks to the

exclusive Twin Drag technology, the drag tension you set will vary no more than two pounds when line is

WIN

pulled off the reel at any speed! Unfortunately, there is another factor which causes drag variance that needs to be accounted for. This

factor is based on how full the reel is with line. When the spool is filled, the line is being pulled off a high point on the spool. As the

amount of line on the spool reduces, the line is pulled from a lower area on the spool. There is less leverage used when the line is

pulled at a lower level, which means the line needs more force to move the spool against the drag. The drag setting has not been

decreased, but the line will encounter increased tension. Account for the drag pressure to approximately double when 25% of the line

has been removed from a full spool.

Reel is no different from operating any other spinning reel except for setting the preset drag. Once