Arcam DV88 Manuel - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Arcam DV88. Arcam DV88 20 pages. Progressive scan output
Également pour Arcam DV88 : Manuel (1 pages), Manuel (18 pages)

Imprimer la page

Using the remote control

Ensure that DVD mode is selected using the

toggle button. The 'DVD' LED above the

Dims or turns the DV88

's display on or off. Turning the display

PLUS

off generally gives a slight improvement in sound quality.

Pressing

DISP

once turns the display off; twice dims the display.

To restore the display to full brightness, press

This button enables you to repeat a selected

section from the disc (see page 12).

Press

RPT

to cycle through the repeat play options.

Fast play and Skip chapter/tracks

Play fast (

) and Skip (

Pause ( ), Play ( ) and Stop ( ) (see page 9).

These buttons are described on the facing page.

DV88

PLUS

CD/DVD

is lit briefly when DVD mode is selected.

DISP (display)

a third time.

DISP

A–B

RPT (repeat)

) chapters/tracks in both

directions (see page 9).

OPEN

Opens and closes the disc tray.

Playback control

Advanced controls

0–9 keypad

This allows direct access to individual tracks on audio CDs. To

button

select a track, press the corresponding keypad button followed

For example, to play track 15, press

CD/DVD REMOTE

DVD

DISP

A-B

RPT

CLEAR

PROG

OPEN

MUTE

SUBT

TITLE

MODE

ZOOM

AUDIO

MEM

RTN

ANGLE

SETUP

STATUS

SRCH

CR-314

. For tracks greater than 9, enter the digits in sequence.

, then

Standby

Press

to toggle the standby state of the DVD player.

Standby

Note that Arcam CD players are not controlled by this button.

CLEAR

Use

CLEAR

within the 'Program' and 'Bookmark' menus to clear

a numeric field (see pages 12–13).

PROG (program)

You can program a selection of up to 20 chapters/tracks

from a disc to play in any order. Press

'Programme' menu (see pages 13 and 15).

Slow play

Press

on the remote control to play slow forward or

backwards. There are four speeds of slow playback: 1/5,

1/4, 1/3 and 1/2. Press the button repeatedly to cycle

through the different speeds. To resume normal playback

speed, press

PLAY

Note that slow play does not apply to audio CDs.

Cursor pad and OK button

Use the cursor pad to navigate the On Screen Display (OSD) and

menu pages. Confirm your selection with the

MUTE

Stops sound to the speaker outputs of certain Arcam amplifiers.

Volume +/–

Adjusts the volume on Arcam remote-controllable amplifiers.

Note that the volume (+/–) controls and

no effect on the audio output level of the DVD players.

NOTE: Remember to install the two AAA batteries supplied

before trying to use your remote control.

Do not place anything in front of the display area on the

DVD player (where the IR receiver is located), or the

remote control may not work.

, then

PROG

to access the

button.

button have

MUTE