Circe Cycles Helios STEPS Manuel d'assemblage - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'assemblage pour {nom_de_la_catégorie} Circe Cycles Helios STEPS. Circe Cycles Helios STEPS 8 pages.
Également pour Circe Cycles Helios STEPS : Manuel du propriétaire (15 pages)
Imprimer la page
Install the triplet section on to the front part of
the bike , pushing it on until the crossbar coupling
meets with the coupling on the frame.
Note - Ensure the brake and gear cable (if
mechanical system) are on the correct side of the
frame before proceeding.
Tighten the coupling on the crossbar first, then
tighten the pinch bolts on the drainpipe (refer
to Appendix A for torque settings). This order is
important, as the coupling aligns the frame, and
the lower section needs to be free to rotate while
this happens.
You can now fit the rear triangle, following the
same procedure used for the front section. For
STEPS equipped bikes the cables will need to be
connected and threaded back into the Triplet
main tube before doing this.
1.
1 - Di2 Alfine hub,
2 - STEPS speed
sensor
3 - lights (if fitted)
2.
INSTALLING THE CHAINS
The middle stoker chain comes separated and
should be installed first; connection is via a quick
link.
6
3.
CirceCycles.com
Depending on the configuration of your triplet, the
front timing chain comes pre-connected and can
be installed without separating. Once the chains
are in place the chains can be lifted on to the
tensioners.
INSTALLING THE CABLES
If you intend to switch between triplet and tandem
mode regularly then we suggest that you use the
Velcro straps provided to hold the cables in place
at the cable mounting points, otherwise the cables
can be held in place with zip ties.