Arcan XL35 Manuel d'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Arcan XL35. Arcan XL35 16 pages. Professional low lift jack

Imprimer la page

ASSEMBLY INSTRUCTIONS

1. Remove 2-piece handle from box. Insert narrow portion

of top section (17) into bottom section (15) and secure

with bolt (16) provided.

2. Grease handle receptacle and insert slotted end of

handle into place. Tighten set screw (13) to secure

handle.

3. Then, slightly press down on the handle assembly to

release pressure on the handle assembly retainer and

remove retainer. This will allow handle to be raised to

operating position.

OPERATING INSTRUCTIONS

BEFORE USE: Air may become trapped in the hydraulic

system during transit. To purge air:

1. Open release valve by turning handle counterclockwise.

2. Pump handle rapidly 4 full strokes. This will expel air

that may have entered oil passages during transit.

3. Close release valve by rotating handle clockwise and

pump handle.

4. If lift arm is raised, jack is ready for use. If not, repeat

this procedure.

IMPORTANT: Before attempting to raise any vehicle, check

vehicle service manual for recommended lifting surfaces.

OPERATION:

1. To raise load: Close release valve tightly (by turning

handle clockwise). DO NOT OVERTIGHTEN. Position

jack under load so that saddle will contact load firmly

and load is centered so it cannot slip. Operate jack

handle until saddle approaches the load. Once again,

check to see that saddle is correctly positioned. Raise

load to desired height. Place jack stands of appropriate

capacity under the vehicle. DO NOT CRAWL UNDER

VEHICLE WHILE LIFTING VEHICLE OR PLACING

OR REMOVING JACK STANDS! Place jack stands

at vehicle manufacturer's recommended lift areas that

provide stable support for the raised vehicle. Once jack

stands are positioned, open the release valve VERY

SLOWLY (by turning the handle counterclockwise).

Lower the load to rest on the jack stands. Then, make

sure that the release valve on the jack is closed tightly

(by turning the handle clockwise).

2. To lower load: Re-check to make sure release valve

is tightly closed. Then, operate the jack handle until

the load is raised enough to remove the jack stands.

DO NOT CRAWL UNDER VEHICLE WHILE LIFTING

VEHICLE OR REMOVING THE JACK STANDS! Once

jack stands are removed, open release valve very slowly

to lower the vehicle. Lower jack completely so that the

vehicle is securely resting on the ground and that jack

no longer makes contact with vehicle.

CAUTION: Keep hands or feet away from the hinge

mechanism of the jack.

XL-35

MAINTENANCE

When adding or replacing hydraulic fluid, always use a

quality hydraulic fluid. DO NOT use brake fluid, alcohol,

detergent motor oil, dirty oil or any fluid other than quality

hydraulic fluid. Improper fluids can cause internal damage

to the jack and improper or unsafe operation.

Adding Hydraulic Fluid

With the saddle fully lowered and the jack on level ground,

remove the filler screw. Hydraulic fluid should be filled to

the level of the filler screw hole. If the level is below this

hole, add hydraulic fluid as needed.

LUBRICATION

All moving joints require lubrication often. Lightly grease

saddle post and saddle bottom. Remove handle and

grease the lower end of handle where it rotates in the

handle socket. Using a grease gun, grease the lift arm pivot

shaft grease fitting until grease appears at the end of the

shaft. Oil all lift arm linkages, front wheels and rear casters.

SPECIFICATIONS

Rated Load Capacity:

Low height

High height

Overall length

Width

Low height reach

Weight

Strokes to Full Height

(without load)

3-1/2 Tons

3-1/2"

21-3/8"

27-1/2"

14"

12-1/2"

104 lbs

rev. 06/27/05