Arcan A41311 Manuel du propriétaire - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Arcan A41311. Arcan A41311 4 pages. 1/2" push button impact wrench

Imprimer la page

WARNING INFORMATION

• Keep away from rotating end of tool. Do not wear jewelry or loose clothing. Secure long hair. Scalping can occur if hair

is not kept away from tool and accessories. Choking can occur if neckwear is not kept away from tool and accessories.

• Do not use (or modify) the tool for any other purpose than that for which it was designed without consulting the

manufacturer's authorized representative.

• Impact wrenches are not torque control devices. Fasteners with specific torque requirements must be checked with

suitable torque measuring devices after installation with an impact wrench.

• Use only impact sockets and accessories on this tool. Do not use hand sockets and accessories.

• Use accessories recommended by Arcan.

• Do not lu bri cate tools with flam ma ble or vol a tile liq uids such as ker o sene, die sel or jet fuel.

• This tool is not insulated against electric shock.

• This tool must not be used in explosive atmospheres.

• Servicing and repairs should only be made by an authorized service center.

• Do not force tool beyond its rated capacity.

• Do not remove any labels. Replace damaged labels.

• Failure to heed these warnings may result in serious or fatal personal injury and/or property damage.

WARNING: This product can expose you to chemicals including nickel, which is known to the State of California to

cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS

WARNING

Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY

WARNINGS, MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID

HAZARDOUS SITUATIONS could cause accidents resulting in serious or fatal personal injury and/or property damage.

INSTRUCTION MANUAL

This product is designed to tighten or loosen threaded fasteners. No other use is permitted.

Whip Hose

Do Not Install

Quick Coupling

Nipple

Here

Leader

Quick Coupler

Hose

fig. 1.

AIR SUPPLY REQUIREMENTS

Tools operate on a wide range of air pressures. It is recommended that air pressure measures 90 psig at the tool with the trigger fully

depressed and no load applied to the tool. Higher pressure (over 90 psig; 6.2 bar) raises performance beyond the rated capacity of the

tool, which will shorten tool life and could cause injury.

Always use clean, dry air. Dust, corrosive fumes and/or water in the air line will cause damage to the tool. Drain the water from air lines

and compressor prior to running tool. Clean the air inlet filter screen weekly. The recommended hookup procedure can be viewed in

the Figure 1.

The air inlet used for connecting air supply has standard 1/4" NPT. Line pressure should be increased to compensate for unusually

long air hoses (over 25 feet). Minimum hose diameter should be 3/8" I.D. and fittings should have the same inside dimensions and be

tightly secured.

Always turn off the air supply, drain hose of air pressure and detach tool from air supply before installing, removing or adjusting any

part or accessory on this tool, or before performing any maintenance on this tool.

Ensure an accessible emergency shut off valve has been installed in the air supply line and make others aware of its location.

A41311

Air Supply

Filter

Nipple

Oiler

Regulator

Drain Daily

1/2" Push Button Impact Wrench

For Technical Questions, Call: 1-800-879-7316

Model A41311

11/08/19