Epson 1160 CFS Manuel d'instructions d'installation - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Epson 1160 CFS. Epson 1160 CFS 12 pages.

Run second cleaning cycle, then another nozzle check. On the second cleaning cycle

there is about 7 seconds worth of pumping and the ink should travel several inches

up the tubes.

If the nozzle check is good, skip the third cleaning cycle. If necessary, run a third

cleaning cycle, then another Nozzle check.

Print 10 pages of the purging image (purge4.tif) then run 3 more cleaning cycles,

then 10 more copies of purge4. Repeat the cleaning cycles and printing of purge4

until the inks reach the cartridges. Check the nozzles. If they are perfect, you are

ready to start printing. If not, run a cleaning cycle and check them again.

If all went well, you are almost finished. You can print some images and use the

printer like you normally would use it. If you see any banding, run a couple of nozzle

check – cleaning cycles. It will clear up.

When the day is done, check your tubes. The ink should be right up to the

cartridges. The next morning, the ink will have retracted a little bit, as much as 4

inches back from the cartridges. This is normal. When you start to print again the

ink will be drawn into the cartridges and it will function normally.

In the morning, if you see the ink has retracted more than half way back to the

bottles, on any of the tubes, this is a problem. It means there is an air leak. There

is no fix for this, other than a new continuous flow cartridge. We will replace it at

no cost if this occurs.

You should enjoy printing with a minimum of problems. Occasionally you will have to

run a couple of cleaning cycles, just like you would have to without the CFS. The

bottles hold approximately 12 cartridges full of ink, when they get to 1/4 full,

remove the top and add more ink. There is no vacuum in the bottles, they are

vented to atmosphere. The tops can be removed at any time.

12. Resetting the Out of Ink Switches –

On the 1160 printer there are two switches in the front of the cartridge holder.

These switches get released and then pushed in each time you remove the Switch

Activators (previously done by the cartridge clamps). These switches control the

lights on the front panel of the printer. When an out of ink condition occurs, the

lights come on and the printer will not print again until the switches are reset.

Removing the cartridges is not desirable. When the cartridges are lifted off of

the printer posts, inside the cartridge holder, an air pocket forms in the

S a v e

M o n e y

a n d

I m p r o v e

Y o u r

P r i n t i n g

MIS Associates Inc

2901 Auburn Rd

Auburn Hills, MI 48326

800-445-8296

http://www.inksupply.com

Fax: 248-289-6013