Axxess ASWC-1 Manuel de l'utilisateur - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Axxess ASWC-1. Axxess ASWC-1 6 pages. Connections
Également pour Axxess ASWC-1 : Instructions d'installation (4 pages), Instructions (5 pages)

Imprimer la page
Axxess ASWC-1 Manuel de l'utilisateur

Manual Programming:

* Note: Not every radio will have all the possible SWC commands on the steering
wheel. Aftermarket radios that do not have Bluetooth will not recognize the PTT (Push
To Talk) or On Hook / Off Hook commands, however those buttons can be manually
programmed to do other commands. Please refer to the radios owners' manual or
wireless remote for specific commands the radio will recognize.
1) Complete connections to the vehicle and the aftermarket radio, making sure the 3.5mm
connector is connected.
* If this is the first time the ASWC is being installed in a vehicle:
2) Turn the ignition on; the led will start flashing rapidly
3) After 10 seconds the ASWC will go into the LED feedback mode. After the series of led
flashes the led will stay in a slow constant flash state. Go to step 4.
Or * If the ASWC has been in a vehicle before:
2) Press and hold the reset button down for more then 10 seconds.
3) After the 10 seconds the led will begin a slow constant flash.
4) At this point press and hold the Volume Up button on the steering wheel for 7 seconds
until the led goes solid red. Now release the Volume Up button and the led goes off. Volume
Up has now been programmed.
5) Now press and hold the Volume Down button until the led goes solid red. Release the
Volume Down button and the led goes off. Volume Down has now been programmed.
6) At this point press and hold the next button on the steering wheel that corresponds with
the programming list (see below). The chart below shows in what order the steering wheel
control buttons need to be programmed in.
If the next function on the list is not on the steering wheel press and hold the Volume Up
button for 1 second till the led comes on then release the button. This tells the ASWC
that the function is not available and moves on to the next function.