Axxess AXAC-FD1 Manuel d'instructions d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Axxess AXAC-FD1. Axxess AXAC-FD1 8 pages. Ford camera interface with pre-wired harness 2011-up

Imprimer la page

Attention! Two different harnesses are provided, one for models with a 4.2-inch display screen radio

(12-pin T-harness), the other for models with an 8-inch display screen radio (54-pin T- harness).

Use the appropriate harness and discard the other. The harness will connect at the display screen.

For models with a factory backup camera:

The camera signal will need to be interrupted and connected to the corresponding input/output

RCA jacks from the interface.

• Connect the RCA jack from the AXAC-FD1 vehicle harness labeled "Camera input", to the RCA

jack from the AXAC-FD1 interface harness labeled "Camera output".

• Connect the RCA jack from the AXAC-FD1 vehicle harness labeled "Camera output", to the

RCA jack from the AXAC-FD1 interface harness labeled "Camera 1".

• Disregard the following (3) wires: Blue/Green, Green/Blue, Red

For models without a factory backup camera:

• Connect the RCA jack from the AXAC-FD1 vehicle harness labeled "Camera input", to the RCA

jack from the AXAC-FD1 interface harness labeled "Camera output".

• Connect the RCA jack from the AXAC-FD1 interface harness labeled "Camera 1", to the

aftermarket backup camera.

• Disregard the RCA jack labeled "Camera output" from the AXAC-FD1 vehicle harness.

• Connect the Red wire from the AXAC-FD1 interface harness labeled "Camera 12V", to the

power wire from the aftermarket backup camera.

• Disregard the following (2) wires: Blue/Green, Green/Blue

CONNECTIONS

Camera Input:

Camera 1

Camera 2

Camera 3

Camera 4

Analaog control trigger wires:

The (optional) analog control wires can be used with either a negative or positive trigger, depending

on how they are configured in the Axxess Updater. These wires will only be used for manual control of

the camera(s). Otherwise disregard them.

Control Wire

Control 1

Control 2

Control 3

Control 4

Blue/Black and Blue/Red input wires (12-pin T-harness):

These wires are only for use with the AXAC-FDSTK (sold separately) for 2014-Up models.

Refer to the AXAC-FDSTK instructions for wiring.

Backup camera input

Left or right camera, user assignable

Front camera

Wire Color

Gray/Blue

Gray/Red

Orange

Orange/White

REV. 3/31/2020 INSTAXAC-FD1