Axxess AX-FT901 Manuel - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Axxess AX-FT901. Axxess AX-FT901 8 pages. Fiat 500 2015 / 500l 2014(with u-connect) data interface with swc & factory display retention †

Imprimer la page

PROGRAMMING THE ASWC-1

INTERFACE

L.E.D. feedback

The (18) Red L.E.D. flashes represent what brand radio the ASWC-1 believes it is connected

to. Each flash represents a different radio manufacturer. For example, if you are installing

a JVC radio, the ASWC-1 will flash (5) times. Following is a legend that dictates which

manufacturer corresponds to which flash.

L.E.D. feedback legend

1 flash - Eclipse (Type 1) †

2 flashes - Kenwood ‡

3 flashes - Clarion (Type 1) †

4 flashes - Sony / Dual

5 flashes - JVC

6 flashes - Pioneer / Jensen

7 flashes - Alpine *

8 flashes - Visteon

9 flashes - Valor

* Note: If the ASWC-1 flashes Red (7) times, and you do not have an Alpine radio connected

to it, that means the ASWC-1 does not detect a radio connected it. Verify that the 3.5mm

jack is connected to the correct steering wheel jack/wire in the radio.

** Note: Part number AX-SWC-PARROT is required (sold separately). Also, the Parrot radio

must be updated to rev. 2.1.4 or higher through www.parrot.com.

† Note: If you have a Clarion radio and the steering wheel controls do not work, change the radio

type to the other Clarion radio type; same for Eclipse. The following section explains how to do this.

‡ Note: If you have a Kenwood radio and the L.E.D. feedback comes back as showing as a JVC

radio, change the radio type to a Kenwood. The following section explains how to do this.

(CONT.)

10 flashes - Clarion (Type 2) †

11 flashes - Metra OE

12 flashes - Eclipse (Type 2) †

13 flashes - LG

14 flashes - Parrot **

15 flashes - XITE

16 flashes - Philips

17 flashes - TBD

18 flashes - JBL

SCREEN OPERATION

Configuration Menu

Vehicle Settings

Interface Settings

Language

Version

< Back

Configuration Menu

• The buttons on the steering wheel will be used to

operate the configuration menu, which will be shown

on the aftermarket radio. To enable the menu, push and

hold the Talk button for 2 seconds. Use the Track Up and

Track Down buttons to navigate through the menu. To

select a menu option, push the Talk button once.

Continued on the next page