Axxess AXDIS-BW122 Instructions d'installation - Page 2
Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Axxess AXDIS-BW122. Axxess AXDIS-BW122 4 pages. Bmw (with m.o.s.t. 25 amplifier) 2004-2013
Imprimer la page
From the aftermarket radio to the AXDIS-BW122 harness, connect the:
• Black wire to the ground wire.
• Yellow wire to the battery wire.
• Yellow wire (6' long w/ fuse-holder) directly to the vehicles battery.
• Red wire to the accessory wire.
• Orange wire to the illumination wire (if applicable).
• Blue wire to the power antenna turn-on wire.
• Brown wire to the mute wire.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Blue/Pink wire to the VSS/speed sense wire.
• Green/Purple wire to the reverse wire.
• Light Green wire to the parking brake wire.
• Tape off and disregard the following (8) wires, they will not be used in this application:
Gray, Gray/Black, Green, Green/Black, Purple, Purple/Black, White, White/Black
• Red and White RCA jacks to the full range amplifier output jacks.
2
CONNECTIONS
AXSWC harness:
This harness is only to be used if the vehicle is equipped with steering wheel controls.
• Connect the Black wire to the chassis ground.
• Connect the Red wire to accessory power.
• For the radios listed below: Connect the 3.5mm adapter to the male 3.5mm SWC jack from the
AXSWC harness. Any remaining wires tape off and disregard:
• Eclipse: Connect the steering wheel control wire, normally Brown, to the Brown/White wire
of the connector. Then connect the remaining steering wheel control wire, normally Brown/
White, to the Brown wire of the connector.
• Metra OE: Connect the steering wheel control Key 1 wire (Gray) to the Brown wire.
• Kenwood or select JVC with a steering wheel control wire: Connect the Blue/Yellow wire to
the Brown wire.
• XITE: Connect the steering wheel control SWC-2 wire from the radio to the Brown wire.
• Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack into the AXSWCH-PAR (sold
separately), and then connect the 4-pin connector from the AXSWCH-PAR into the radio.
Note: The radio must be updated to rev. 2.1.4 or higher software.
• Universal "2 or 3 wire" radio: Connect the steering wheel control wire, referred to as Key-A or
SWC-1, to the Brown wire of the connector. Then connect the remaining steering wheel control
wire, referred to as Key-B or SWC-2, to the Brown/White wire of the connector. If the radio
comes with a third wire for ground, disregard this wire.
Note: After the interface has been programmed to the vehicle, refer to the manual provided with
the radio for assigning the SWC buttons. Contact the radio manufacturer for more information.
• For all other radios: Connect the 3.5mm jack from the AXSWC harness, into the jack on the
aftermarket radio designated for an external steering wheel control interface. Please refer to the
aftermarket radios manual if in doubt as to where the 3.5mm jack goes to.