Axxess AXTC-FD3 Manuel d'instructions d'installation - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Axxess AXTC-FD3. Axxess AXTC-FD3 12 pages. Ford swc (steering wheel control) and data interface 2020-up
Imprimer la page
The AXTC interface can be used in vehicles without steering wheel controls to provide retained accessory power, and also to provide wires
for multimedia radios (park brake / reverse / speed-sense). Follow the steps below to program the AXTC-CH5 for just these features.
1. From the 3.5mm adapter, tie the Brown and Brown/White wires together and tape up or use a connector.
2. Connect the 3.5mm adapter to the 3.5mm jack from the AXTC-CH5 harness.
3. Program the AXTC-CH5 per the AXTC-CH5 instructions, page 3. Disregard steps 4 and 5.
• At the end of programming the LED light will turn solid
• If the LED light turned solid
• If still no success after resetting and reprogramming the interface, refer to the Vehicle Troubleshooting document for
the interface. Ignore the steps referencing steering wheel controls.
Final LED Feedback
Red
instead, this means programming has failed. Reset the interface and try again.
LED Light
Solid Green
Solid Red
Integrate •
© COPYRIGHT 2019 METRA ELECTRONICS CORPORATION
ADVANCED PROGRAMMING
Green
which indicates programming was successful.
Vehicle Programming Section
Pass
Fail
AxxessInterfaces.com
AXTC SERIES
REV. 6/19/19