Configuring the Network Interface Using EpsonNet Config with
Web Browser
After you have assigned an IP address to the network interface using the printer's Control
panel, EpsonNet Config for Windows or Macintosh, a DHCP server, or the arp/ping
command, you can configure the network interface using EpsonNet Config with Web
Browser.
Note:
❏ A Web browser must be installed on your computer.
❏ TCP/IP must be correctly set for the computer and the network interface.
Follow the steps below to change the IP address using EpsonNet Config.
1. Turn on your printer.
2. Run EpsonNet Config in one of the following ways.
❏ Run EpsonNet Config for Windows or Macintosh. Select the printer you want to
configure from the list and then click Launch Browser.
❏ Open your browser, and then type in the IP address of the network interface
directly. Do not run EpsonNet Config for Windows or Macintosh.
http://IP address of network interface/
Example: http://192.168.100.201/
Note:
To check the IP address of the network interface, use EpsonNet Config. For details, see
"EpsonNet Config for Windows" on page 25 or "EpsonNet Config for Macintosh" on page 26.
3. Click TCP/IP under Network on the Configuration menu to display the TCP/IP setting
screen.
4. Select a method for acquiring the IP address. When you select Auto, DHCP becomes
available and assigns an IP address automatically. If you want to set the IP address
manually, select Manual.
Note:
❏ The network administrator must check any changes made to the IP address settings.
❏ When Auto is selected, DHCP becomes available. To use the DHCP server, make sure it
is installed on your computer and correctly configured. See your operating system's online
help for detailed instructions.
❏ If Set Using Automatic Private IP Addressing (APIPA) is enabled, a private IP
address is automatically assigned to the network interface even when there are no DHCP
servers on your system or your network.
28
Network Software
Imprimer la page