DigiDesign AI16 Manuel de démarrage rapide - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} DigiDesign AI16. DigiDesign AI16 12 pages. Analog input card for mix rack

Imprimer la page
Find the Hub48 Board ribbon cable that corresponds to the
10
input slot in which you have installed the AI16 Card. The
Hub48 board's five ribbon cables connect to the Input and
Output Expansion Cards.
Do not remove or re-seat the ribbon cable connections on
the Hub48 Board while the board is installed in the Mix
Rack. This may cause excessive flexing of the Hub48
Board. If necessary, disconnect the Hub48 and all Expan-
sion Card ribbon connections, and remove the entire assem-
bly from the rack prior to changing connections.
.
Detail of back of Mix Rack, the Hub48 Board, and the ribbon cables
Mix Rack contains 5 ribbon cables that connect to the Input
and Output Cards. The bottom three ribbon cables connect
to the AI16 Cards installed in Slots A, B, and C.
Connect the AI16 Card's ribbon cable socket.
11
Make sure the pins on the socket are correctly aligned with the
ribbon cable connector. Secure the connection by moving the
retaining clips on each side of the socket connector inward.
Check to make sure the ribbon cable is connected securely.
A properly connected Expansion Card
4
AI16 Analog Input Card
Hub48 Board
Connects to Card in
Slot C
Connects to Card in
Slot B
Connects to Card in
Slot A

Removing an AI16 Card

If you want to replace an AI16 Input Expansion Card in your
Mix Rack, you must first remove a card.
To remove an AI16 Card:
Shut down the VENUE system, and turn off power to the
1
Mix Rack.
Disconnect all cables from Mix Rack.
2
Remove Mix Rack's front panel cover by unscrewing its
3
mounting screws (#1 Phillips).
On the back panel, locate the input card you want to re-
4
move.
Remove the mounting screws that secures the output card to
5
the front panel of Mix Rack's chassis.
Disconnect the card's ribbon cable.
6
Loosen the thumbscrews that secure the input card to the
7
Mix Rack's chassis.
Gently slide the card out of the slot.
8