Epson AcuLaser C4000 Référence rapide - Page 9
Parcourez en ligne ou téléchargez le pdf Référence rapide pour {nom_de_la_catégorie} Epson AcuLaser C4000. Epson AcuLaser C4000 23 pages. High performance colour lasers
Également pour Epson AcuLaser C4000 : Brochure & Specs (24 pages), Manuel de configuration (48 pages), Brochure & Specs (6 pages)
Imprimer la page
Paper Set XXX YYY
The paper loaded in the specified paper
source (XXX) does not match the required
paper size (YYY). Replace the loaded paper
with the correct size paper and press the N
Start/Stop
button
press the q Job Cancel button to cancel the
print job.
If you press N Start/Stop
replacing the paper, the printer will print on
the loaded paper even though it does not
match the required size.
Printer Open
Cover A, cover B, cover D, or some
combination of these covers are open. To
clear this error, close all covers.
Print Overrun
The required time to process the print data
exceeded the print engine speed because the
current page is too complex. Press the N
Start/Stop
button
press the q Job Cancel button to cancel the
print job. If this message appears again,
select On as the Page Protect setting in the
control panel's Setup Menu.
If you continue to receive this message when
printing a particular page, try simplifying
the page by limiting the number of graphics
or reducing the number and size of fonts.
You can also add more memory to the
printer as described in "Memory Modules"
in the Reference Guide.
PS3 Hard Disk full
The memory allocated for writing PostScript
3 commands on the optional Hard Disk
Drive is full.
to resume printing. Or
without
button
to resume printing. Or
EPSON AcuLaser C4000 Quick Reference
To clear this error, select Clear Warning
from the control panel's Reset Menu. For
instruction about accessing the control panel
menus, see "How to access the control panel
menus."
RAM Check
The printer is checking the RAM.
Ready
The printer is ready to receive data and print.
Replace Photoconductor
Printing has stopped to avoid damage to the
engine. Turn off the printer, then replace the
photoconductor unit with a new one. See
"Photoconductor Unit" in the Reference
Guide for instructions.
The error clears automatically after you
replace the unit and close all printer covers.
The photoconductor service life counter is
reset automatically.
Replace TransferUnit
The transfer unit has reached the end of its
service life. Turn off the printer, then replace
the transfer unit with a new one. See
"Transfer Unit" in the Reference Guide for
instructions.
The error clears automatically after you
replace the unit and close all printer covers.
The transfer unit service life counter is reset
automatically.
(9/22)