Creda Non pumped Manuel d'installation et d'utilisation - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Creda Non pumped. Creda Non pumped 10 pages. Thermostatic digital mixer shower electronic remote control mixer shower
Imprimer la page
How the shower works
The shower is a remote controlled mixer shower incorporating a booster pump. (On the non pumped
model the booster pump is replaced by a motorised flow regulator valve). It is controlled by a remote
control unit that is installed in a shower cubicle along with the shower accessories.
Switch on and running
• The remote control is used to switch the base unit on and control the temperature and flow rate
• The remote control and base unit send the instructions to each other using radio frequency signals
with a maximum range of about 10 metres.
Pumped model and remote control (3 preset version shown)
Non Pumped model
_16_
b) Locating the base unit
DO NOT install the base unit in the bathroom or shower cubicle area.
DO NOT install the base unit upside down (i.e. secured to a ceiling)
• In general the base unit can be installed above the shower cubicle in the loft or adjacent to it in an
airing cupboard. (Or other suitable location within 10m of the shower area)
• The unit can be mounted horizontally ("on its back"), or vertically.
• When mounting vertically, the connection pipes MUST be pointing down.
P
O
• Ensure that the location is not subject to freezing or excessive moisture.
c) Fitting and Plumbing
Mark up and fix
• Decide where to mount the base unit ensuring :
- There is adequate clearance for access around the base unit, including connection of the hot
and cold and shower delivery pipes.
- The distance between the base unit and the shower cubicle is less than 10m.
- There are no metal coated ceiling panels or metal partitions between the base and the shower.
(Metal panels etc. can block the remote control signals and so stop the unit working correctly)
• Mark the four locating points for the base and then secure using the screw pack provided.
Important : In all cases, the unit must be mounted using the rubber
feet and spacers supplied. Some surfaces, such as hollow walls, may
require a different screw and plug type (not supplied)
Mounting feet, spacer and screws
• Once the base unit is fixed in position the plumbing connections can
be attached.
Plumbing – General
• The cold and hot water supplies must be flushed through prior to making the connections to the
base unit, to remove all particles from the pipe work and help with priming during commissioning.
O
O
• Connections are made to the unit using
15mm straight or elbow couplers (Push
fit or compression). The cold and hot
water connections should include service
valves for ease of maintenance.
(Filtered isolation valve available as an
ancillary – See Page 19)
___Cold and hot inlets, and outlet (mixed)
___connections.
_5_