ARCHIPELAGO LIGHTING LED SL-4RM Instructions d'installation

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} ARCHIPELAGO LIGHTING LED SL-4RM. ARCHIPELAGO LIGHTING LED SL-4RM 4 pages. Led shop/utility light

Imprimer la page

PREPARATION

Before beginning installation of the product, make sure

all parts are present. If any part is missing or damaged,

do not attempt to assemble, install or operate the

product.

Estimated Assembly Time: 10 Minutes

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install the product

WARNING: RISK OF SHOCK

House electrical current can cause painful shock or serious injury unless handled properly. For your safety, always

remember to:

-Turn off the power at the fuse or circuit breaker box before you install the shop light.

2. This shop light is designed for use in a circuit protected by a fuse or circuit breaker. This shop light is intended to be

installed

directly beneath a ceiling-mounted receptacle and any excess cord should be kept out of the workspace. It is

also designed to

installed in accordance with local electrical codes. If you are unsure about your wiring, consult a

qualified electrician or local

3. Account for small parts and destroy packing material, as these may be hazardous to children.

WARNING: RISK OF INJURY

Do not open shop light. No serviceable parts inside.

WARNING: RISK OF FIRE

Most dwellings built before 1985 have a supply wire rated 60˚C. Do not overload the circuit and wiring. Consult a

qualified

electrician.

This device complies with part 15 of the FCC Rules.

(1) This device may not cause harmful interference, and

interference that may cause undesired operation. Note: This

limits for a Class B digital device, pursuant to part 15 of the FCC

protection against harmful interference in a residential installation

frequency energy and, if not installed and used in accordance with the

radio communications. However, there is no guarantee that interference

equipment does cause harmful interference to radio or television reception,

equipment of and on, the user is encouraged to try to correct the interference by one

Reorient or relocate the receiving antenna. Increase the separation between the equipment

equipment into an outlet on a circuit different from that to which the receiver is connected. Consult

experienced radio/TV technician for help.

LIMITED WARRANTY

For 5 years from the date of purchase, this product is warranted for the original purchaser to be free from defects in

materials and workmanship through normal use. In order to obtain this service, please return this item to the place of

purchase with valid proof of purchase and the defective product will be replaced at no charge. This guarantee gives

you specific legal rights, and you may have other rights that vary from state to state.

This shop light was carefully packed and thoroughly inspected before leaving our factory.

ARCHIPELAGO LIGHTING | MONTCLAIR, CA (866) 912-3220 FAX (909) 627-2887 www.archipelagolighting.com

5012662

electrical inspector, and consult your electrical code.

INSTALLATION INSTRUCTIONS

PACKAGE CONTENTS

PART

DESCRIPTION

Fixture

Assembly

Install screw

Chains

"J" Hooks

Wall anchors

Operation is subject to the following 2 conditions:

(2) this device must accept any interference received, including

equipment has been tested and found to comply with the

Rules. These limits are designed to provide reasonable

This equipment generates, uses and can radiate radio

instructions, may cause harmful interference to

will not occur in a particular installation. If this

which can be determined by turning the

LED SHOP/UTILITY LIGHT

D SL-9/4/7.5/40/4RM

QUANTITY

or more of the following measures:

and receiver. Connect the

the dealer or an