Creek Company OUTDOOR DISCOVERY CRAFT ODC SUPERSPORT XR Instructions de montage - Page 4
Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} Creek Company OUTDOOR DISCOVERY CRAFT ODC SUPERSPORT XR. Creek Company OUTDOOR DISCOVERY CRAFT ODC SUPERSPORT XR 4 pages.
Imprimer la pageODC SUPERSPORT XR
your OdC Outdoor discovery Craft
IF yOU EVER HAVE ANy qUESTIONS OR PROBLEMS WITH yOUR OdC SUPERSPORT XR
NOT RETURN IT TO THE dEALER yOU BOUgHT IT FROM. PLEASE CONTACT THE CREEK COMPANy
dIRECTLy TOLL FREE AT 1-800-843-8454. WE ARE OPEN M-F 9AM-5PM MOUNTAIN TIME. OR CONTACT US
1. Always wear a US Coast Guard approved personal flotation device when in your ODC SUPERSPORT XR
2. Never float alone.
3. Always check your ODC SUPERSPORT XR
4. Never use your craft if you suspect the Air Bladders, outer skin or stitching has been damaged.
5. Never overinflate your ODC SUPERSPORT XR
6. Never use your ODC SUPERSPORT XR
7. Your ODC SUPERSPORT XR
1. If your Pontoon Bladder is losing air, please check that Valve Assembly and Top Valve Cap are fully seated. Reseat valve
assembly and repeat pontoon inflation instructions.
2. Do not store your ODC SUPERSPORT XR
3. If you are leaving your ODC SUPERSPORT XR
pressure inside the Pontoons to a dangerous level. Let some of the air out of the pontoons if the craft will be out of the water in the
sun for any length of time, or if it is stored in a vehicle, etc.
4. A gain in altitude will increase the pressure in the Pontoons also. If you are taking your inflated ODC SUPERSPORT XR
low elevation to a high elevation, be sure to let some of the air out of it.
5. For short term storage, we recommend you let some air out of your pontoons.
6. For long term storage, we recommend you make sure your ODC SUPERSPORT XR
the sunlight in a cool dry area.. Do not store your wet ODC SUPERSPORT XR
Frame and other component damage.
7. Repairing Bladder, use enclosed patch kit. Identify puncture. Fully deflate Bladder. Clean and dry area around puncture. Apply
glue to puncture area and patch using applicator straw. Press patch over puncture area. Allow 24 hours to dry, before inflating.
8. Note: Metal parts may rust and are not covered under warranty.
Accessories are available for your ODC SUPERSPORT XR
The Creek Company Ltd. , PO Box 773892, Steamboat Springs, CO 80477
All Creek Company products are guaranteed against defects in material and workmanship for the life of the product to
the original owner. This does not cover damage due to misuse or normal wear and tear.
OUTDOOR DISCOVERY CRAFT
Please follow inflation instructions and warnings carefully.
VIA E-MAIL AT [email protected].
HIN
IS LOCATEd ON SqUARE TUBINg OF SEAT SUPPORT FRAME MEMBER
ANd ON RIgHT MAIN FRAME MEMBER (SEE FIgURE 1)
Warning:
Please read and follow carefully.
Air Bladders, outer skin and stitching for possible damage before you use your craft.
.
without the Pontoons fully inflated.
is not designed for use in salt water.
CARE AND MAINTENANCE:
in direct sunlight.
out in the sun for any amount of time, be aware that the heat can increase the
or visit the Creek Company Store at www.CreekCompany.com
email: [email protected] • Made in China
Specifications and other details subject to change without notice.
is designed to give you many years of service.
in freezing temperatures as this may result in
™
. Ask for them where you bought your ODC SUPERSPORT XR
TM
TM
.
is completely dry, deflated and stored out of
PLEASE dO
from a
™
,