Creint GP 150/1 Manuel d'utilisation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Creint GP 150/1. Creint GP 150/1 12 pages. Creint grinder professional

Imprimer la page

Declaration of conformity

The Creint professional grinders are in conformity with the

2006/42/EC

2014/30/EC

2014/35/EC

The grinder is standard equipped with a switch with no volt release.

The grinder has thermal overload protection.

Always wear safety spectacles.

Thank you for choosing Creint.

You will get many years of useful service from the machine. Read this manual, keep it and follow the

operating instructions. Creint grinders are for grinding of steel or equivalent materials. Needed tooling: a

spanner no 8 and 10.

Before starting

Check if all needed parts are packed in the box.

Check if the mains voltage corresponds to the

data on the machine plate. Always connect the

machine on an earthed mains voltage. Does the

machine operate on three-phase current? Ask a

electric technicial to connect. When unpacking,

the grinder is nearly ready for use.

Fix the spark arrestor with eye shields and the

grinding supports. Fix the spark arrestor as close

as possible to the grinding wheel. The maximum

distance is 2mm. Then fix the grinding support.

The maximum gap between the grinding support

and the grinding wheel is 2mm. The topside of

the grinding support is +/-3mm under the middle

of the grinding wheel. As a grinding wheel is

wearing, check the gap regularly and change the

wheels when the diameter of the grinding wheel

of 150mm gets <100mm and <134mm of a 200mm

grinding wheel. After any replacement, fix the nuts

carefully.

When using a Creint grinder on a work bench: first

remove the rubber buffers and fasten with wood

screws and retaining rings. When placing a Creint

grinder on a pedestal: remove the rubber buffer

and fasten to pedestal, and use a M6 bolt/nut.

Machines completed with a Creint steel wire brush

must be fixed on a workbench or pedestal.

When using a steel wire brush on the machine,

European Machinery Directive

Electromagnetic compatibility

Low Voltage Directive

delete the grinding support to avoid that the work

piece can come between brush and support.

The best way to work

Allow the grinder to reach full speed before

starting grinding.

Work with a minimum of pressure of the tool

against the grinding wheel sothat the wheel can

do its metal removing work. Too much pressure

only results in less power supply and exta

motorheating by rubbing.

The duty is S2-60 which means running 30

minutses on load and then a cooling down on no

load.

Safety instructions

Follow the instructions in order to reach the best

result. Use an appropriate machine. The right one

for the activities to do. Wear safety spectacles.

Use a face or dust mask in case the operations

produce dust or flying chips. Connect the grinder

on an earthed mains voltage. Never run a grinder

without the wheel guard and wheel guard cover

fitted. Keep children away. Do not allow other

persons to touch the machine. Supervision is

required for those under 16 years of age. Keep

your work area clean. Consider work area

environment. Dress properly. Do not wear loose

clothing or jewelry. This can be caught in moving

parts. Tie long hair together. Do not expose electric

machines to humidity. Keep working area well lit.

Do not use electric machines in the precense of