Digikeijs DR4088OPTO Manuel d'instruction - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Digikeijs DR4088OPTO. Digikeijs DR4088OPTO 11 pages. Feedback module
Également pour Digikeijs DR4088OPTO : Manuel (8 pages), Manuel d'instruction (14 pages), Manuel d'instruction (12 pages), Manuel d'instruction (15 pages)
Imprimer la page
- 1. Table of Contents
- 2. General Informa on
- 3. Index
- 4. Warranty and Warranty Condi1Ons
- 5. Legal Informa1On
- 6. Product Overview
- 7. General Product Informa1On
- 8. Technical Specifica1Ons
- 9. Hardware Overview
- 10. Programming
- 11. DDR4088LN-XX Reset
- 12. Connec on Examples
- 13. Feedback Modules DR4088CS; 2-Wire Track
- 14. Feedback Modules DR4088OPTO; Hall Sensors, 3-Wire Track
- 15. Feedback Modules DR4088GND
DR4088CS / GND / OPTO
3.0 Programming
First, something fundamental about the S88(N) Bus®:
The S88(N)® bus is a universal bus system.
The S88(N)® bus supports a maximum of 256 feedback addresses.
The addresses are always assigned automa1cally and con1nuously. No universal and unique addressing is possible because the S88(N)® bus is not
designed for individual address assignment!
The S88(N)® can only be set up as a bus (line) network. This always means from 1. feedback to 2. feedback, etc.
3.1 Programming DR4088xx (Assign start address in DR50xx)
The S88(N)® bus system does not provide programming in the actual sense. It only has to be defined in the central with which address the S88(N)® bus starts
and how many modules are located on the bus.
Programming the start address in the DR50xx
1.
Start the DR50xx tool.
2.
Call up the sePngs for the S88(N)® bus with the bu2on in the ext88N tool.
3.
The start address and the number of modules must now be entered in this input mask.
www.digikeijs.com
® R-Bus, B-Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz
P 6