Digikeijs DR5000 Manuel rapide - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel rapide pour {nom_de_la_catégorie} Digikeijs DR5000. Digikeijs DR5000 5 pages.
Également pour Digikeijs DR5000 : Manuel rapide (12 pages)

Imprimer la page

DR5000 DIGICENTRAL

18.02.2019

What can I set under LAN everything?

You can adjust the LAN seIngs using the conﬁgura-on soKware. (Normally, the DR5000 recognizes the IP address automa-cally. This requires the DR5000 to be connected

to the home network.) If the DR5000 does not recognize its IP address, it must be searched for in the network router and then entered in point 1) below. If you do not have

suﬃcient knowledge of network technology, the default seIngs should not be changed. Incorrect entries can result in the internal router no longer being accessible and

having to be reset.

IP address of the DR5000

DR5000 Protocol: This seIng is used to select which protocol is made available via LAN or WLAN. The protocol is

then routed to WLAN and LAN. If, for example, LocoNet® Binary has been selected as the protocol and a control

program is connected to the DR5000 via LAN, the program can only access the DR5000 via this protocol.

Possible protocol se ngs:

XpressNet® LAN:

Protocol to connect an external application to the DR5000 via XpressNet® LAN.

LocoNet® over TCP/IP LBServer:

Protocol to connect an external application (such as JMRI) to the DR5000 via LocoNet® TCP / IP.

LocoNet® Binary:

Protocol to connect an external application (recommended for iTrain®/Windigipet® etc.) to the DR5000 via Lo-

coNet® Binary.

Dr. Command:

Protocol to connect to Digikeijs applica-ons.

Z21®/WLANmaus®:

Protocol to connect one or more Roco® WLAN Mice® or App's to the DR5000.

This protocol cannot be used to connect to control soKware when using Z21App® and/or Roco® WLAN mice at

the same +me.

Important!

This UDP protocol (without end-to-end control) is not op-mally suited as a connec-on to a control

soKware because data losses can occur between the DR5000 and the soKware!

LAN Addresses: It is recommended to leave the connec-on type at DHCP. SeIngs should only be made by expe-

rienced users.

LAN Opera+ng mode: It is recommended to leave the connec-on type at DHCP. SeIngs should only be made by

experienced users.

If the DR5000 is not connected via the Lan interface to the home network (router) or via Wlan to the PC or laptop, the Lan seIngs of the DR5000 are grayed

out and not accessible and therefore cannot be changed! A connec-on via USB to the DR5000 is always required to change the Lan seIng!

www.digikeijs.com

Please pay a0en-on!

P 3