Cres Cor 1000-CH-SS-SPLIT-D Manuel d'installation, d'utilisation et d'entretien - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'installation, d'utilisation et d'entretien pour {nom_de_la_catégorie} Cres Cor 1000-CH-SS-SPLIT-D. Cres Cor 1000-CH-SS-SPLIT-D 12 pages. Radiant ovens
Également pour Cres Cor 1000-CH-SS-SPLIT-D : Manuel d'installation, d'utilisation et d'entretien (13 pages)
Imprimer la page
5925 Heisley Road • Mentor, OH 44060-1833
HOW TO USE THE COOK-N-HOLD CONTROL:
*Push the lighted switch on the control panel; the light will
come on and the cabinet will start heating.
*The display will read "LOTPR" (low temperature) below
140°F. (60°C.).
NOTE: Wait one (1) hour after start up before loading the
food for best results.
The display will read "PREHT" until the cabinet reaches
the set temperature, then it will show "READY".
Cooking:
1. Press the COOK button.
2. Turn the control knob to the desired cooking
temperature between 200°F (93°C) and 350°F (176°C).
3. Push the knob to set the temperature.
4. The control automatically goes to the HOLD mode.
(Continue to step 1 below).
Holding:
(Press the HOLD button only if you are just holding food),
1. Turn the control knob to the desired holding temperature
between 140°F (60°C) and 220°F (104°C).
2. Push the knob to set the temperature.
3. The control automatically goes to the TIME mode.
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
OPERATING INSTRUCTIONS
Setting the time or Food Probe:
1. If NOT using the Food Probe:
a) Turn the control knob to the desired hours/minutes.
b) Push the knob to set the time.
2. Using the Food Probe:
Plug in the food probe BEFORE you enter the TIME
mode. Otherwise, you have to press the PROBE button
to set the probe temperature.
a) Turn the knob to the desired temperature.
b) The timer will stop when the probe reaches the set
temperature.
3. Press the START button. The display will read
"PREHT" until the cabinet reaches the set temperature,
then it will show "READY".
4. Press the START again to use this recipe (see Recipes").
Note: Press the knob for 4 seconds to cancel the recipe.
The DISPLAY button shows (cycles through) all the values
when in each mode:
•
"PREHEAT" OR "READY": momentarily shows the
actual cabinet temperature.
•
"COOK" (Timed): shows Home screen, set point,
count down time, actual cabinet temperature.
•
"COOK" (Probe): shows Home screen, set point, count
up time, actual cabinet temperature.
•
"HOLD": shows Home screen, set point, count up
time, actual cabinet temperature.
FL-2340-D
Ovens
Rev. 0 (5/13)
Page 5 of 12