Digilock NEXT cue Manuel du produit - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel du produit pour {nom_de_la_catégorie} Digilock NEXT cue. Digilock NEXT cue 6 pages. Rfid interface bolt mechanism
Également pour Digilock NEXT cue : Manuel du produit (5 pages), Manuel d'installation (16 pages)

Imprimer la page
Digilock NEXT cue Manuel du produit
Support
Error Condition Indicators
10 rapid beeps:
The lock is binding, meaning either door alignment or items in the locker are preventing the lock from operating. Press on the door while
operating the lock. If error condition persists, contact Digilock support for assistance.
2 s ets of three beeps:
The batteries are low. Replace the batteries.
Does not Unlock with the User RFID Credential or User Key
The lock does not recognize the User RFID or User Key. For immediate access, operate with a valid Manager Credential. If in assigned use
functionality, follow instructions to Assign User Credentials to assign a new User RFID Credential or User Key to the lock.
Does not Operate with a Manager Key or Manager RFID Credential
The lock does not recognize the Manager Key or Manager RFID Credential. Follow instructions to Add Manager Keys and RFID Credentials
to program the Manager Key or Manager RFID Credential to the lock. For immediate access, operate with another valid Manager Key or
Manager RFID Credential.
Does not Operate with the Programming Key
The lock does not recognize the Programming Key. If the Programming Key has been replaced, operate with the Replacement
Programming Key. Contact Digilock support for additional assistance.
No Audible Feedback when ` is Pressed
▪
The batteries may need to be replaced. For immediate access, operate with a valid Manager Key.
▪
The front unit may not be properly connected to the rear unit. Remove the lock from the door and check the connection.

Battery Replacement

It is not necessary to uninstall the lock from the door. In case of battery failure, operate with a valid Manager Key.
1
Remove the screws and the cover plate.
081418
PG-NLQR-AP-DEN
Product Guide
(shown with cable rear unit)
2
Pull the battery pack from the rear housing.
Replace with four premium alkaline AA batteries.
RFID Interface
Latch Mechanism
Assigned Use Functionality
3
Place the battery pack back into the rear
housing and screw cover plate in place.
www.digilock.com | [email protected]
Phone: 707 766 6000