Digilock DL310 Instructions pour l'utilisateur

Parcourez en ligne ou téléchargez le pdf Instructions pour l'utilisateur pour {nom_de_la_catégorie} Digilock DL310. Digilock DL310 6 pages. Digital lock

Imprimer la page

DL310 Digital Lock User Instructions

1. Default User Code: 0

After the 4 x AA batteries are installed, without altering any settings, press "0" then "#" to open the

door directly. Once the first user code is programmed, the default code of '0' will no longer unlock the

handle.

2. Changing Master Code:

2.1 Master code: Adding and deleting of Guest Code/TM Key Users.

The Master code cannot be used for unlocking the door

2.2 The default Master code: 123456

2.3 Master codes should be between 4-8 digits.

2.4 Prior to modifying the Master code:

2.41 Reset the Master code:

Operating instructions

Loosen the two screws on the rear panel of

the digital lock, remove the rear panel, press

the button below the batteries for ten

seconds.

Note: This operation will clear all Guest Code/TM Key Users

2.42 Prepare the New Master Code, 4-8 digits (eg: 12345678)

Changing the Master code

2.5

Operating instructions

1 Press "#" to start the lock

2 Input the Default Master code: 123456,

then press "#"

3 Within ten seconds (before the indicator

light switches off) input "11" then "#"

4 Input the New Master Code, (4-8digits)

then "#"

5 Input the New Master Code again, then "#"

confirm.

Add Normal Users

3.1 Maximum of 200 Users, including Code Users, TM Key Users, and Code&TM Key Users.

3.2 Set the User Group before adding the Normal User, each Group represents one User.

Group No. = 3 digits, from 001 to 200, groups cannot be reused.

# Master Code # / Program Code # / Group No.# / Guest Open Door Code# / ##

（11#）

（01#）

Lock status

One "Beep" and red light will flash, After ten seconds,

lock will "Beep" two times, and the blue indicator light

will flash. Master code is now reset to 123456.

Lock status

"Beeps" twice, keypad lights up, blue light flashes.

Lock status as above

"Beeps" four times, indicator light switches off. New

Master Code is set.

Page1