crescendo WS G4 Manuel - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} crescendo WS G4. crescendo WS G4 6 pages.

Quick Start Guide for Crescendo/WS

2. Press on the right side of the Crescendo card until the connectors are com-

pletely coupled (Figure 16); the Crescendo card should be level with the

logic board.

Reinstall Heat Sink Plate

1. Insert the tabs on the edge of the heat sink plate into the PowerBook, then

lay the plate flat (Figure 17).

2. Gently press down on the lower section of the heat sink plate, then secure

the plate with its two screws (Figure 18). Do not overtighten the screws.

Reassemble Computer

1. Flip the keyboard over, and insert the tabs at the top of the keyboard into the

slots in the PowerBook case (Figure 19). Press down on the keyboard until it

snaps into place.

2. Install the battery and expansion module(s) back into the expansion bays

(Figure 20).

3. Connect the power cable to the PowerBook, but leave other cables discon-

nected for now.

4. Affix the Powered by Sonnet label to your computer.

WARNING:

Do not shut down or otherwise interrupt the operation

of your PowerBook during the next three steps. If this process is inter-

rupted, your PowerBook may be left in a disabled condition that is very difficult

to remedy.

Turn On Computer

1. Press the Power button on your PowerBook. You will not hear the normal start-

up sound, but instead a long tone; the display will remain blank.

2. During the next 30 to 45 seconds, the hard drive will spin up and you will

hear eight tones.

3. Your PowerBook will restart. Your accelerated machine should boot normally.

If you have just installed a Crescendo/WS G3 card, or if Mac OS 9.1 or later is

already installed on your system, your PowerBook is ready to use and your installa-

tion is complete. Otherwise, continue to page 6.

battery

Crescendo/WS

Figure 16

heat sink plate

Figure 17

heat sink plate

screw

Figure 18

keyboard

Figure 19

CD-ROM drive

Figure 20