Accusound ES 25 Manuel d'instruction - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Accusound ES 25. Accusound ES 25 4 pages. Eclipse series home theatre satellite system

Imprimer la page

Speaker Cable

Use good quality Oxygen Free Copper cable. Look for wire with polarity (+ & -) markings on the

outside of the jacket. This will help you determine which wire is the positive and negative at both

the receiver and speaker ends of the cable. This is very important. Red for positive and black for

negative.

Your Receiver

If you have a 7.1 or 7.2 receiver and are only running 5.1 we have found customers connecting the

rear speakers to surround back. This is wrong. Connect your rear speakers to surround terminals.

Surround back is for 7.1 or 7.2

Speaker Connection

On the back of the speakers there are 2 push connection terminals. Red is positive (+) and

Black is negative (-). From your receivers positive terminal connect the wire with the (+)

mark or marking to the Red terminal on the speaker. Connect the negative wire to the

Black terminal.

Subwoofer connection

On the rear panel of the ES 25 powered subwoofer are 2 sockets. The top socket is the

subwoofer input and the bottom socket is the subwoofer output. The output is to connect a

second subwoofer to produce more bass if required. This is .2. Use a good quality subwoofer

shielded cable from the subwoofer out on your receiver. This will stop any interference from

other electrical appliances.

Subwoofer Control Panel

Volume Control

The volume control runs from 0-10. We suggest the volume be set to 5 and then controlled by the

subwoofer setting on your receiver. When listening to movies or music make sure that the subwoofer

does not go into distortion. You can hear this as a distorted crackling sound which is usually caused

when the subwoofer level on your receiver is set too high. Ease the volume back so you get a good

solid bass. This will ensure the subwoofer will play for years to come.

Crossover

The crossover is the heart of the ES40 system. As you turn the crossover control up you add upper

bass. The best set up is to fill the gap between the speakers that can not produce lower bass. At

normal levels the speakers go down to 120Hz. The control starts at 40Hz and goes to 200Hz. We

suggest around 120 Hz to start. You can add or decrease the frequency to achieve the correct

balance for either music or movies. The control only adds higher frequency. It does not alter the low

frequency.

Base Extension

This control adds extra depth to the frequency you have the crossover control set to. We call this

bass extension. The control starts at 0dB which is normal. If you find you are not getting the extra

bass and feeling from the subwoofer you can increase the Bass Extension to get the desired effect.

Phase Control

This function adjusts the phase of the subwoofer driver. This adjustment is required to ensure that

the subwoofer and all other associated loudspeakers operate "in sync." If your main speakers are at

the front of the room the woofers are pushing forward. If your subwoofer is at the front of the room

the woofer will be pushing forward. Turn the phase control to 0. At the back of the room the

subwoofer is pushing in an opposite direction. Turn the phase control to 180 degrees and the

subwoofer will fire in the opposite direction and be in sync. If you place the subwoofer at the side of

the room you run between 40~160 degrees. To hear bass all around the room you will have to adjust

the phase to find the best setting.