Cisco 3750 - Catalyst EMI Switch Manuel de démarrage - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Cisco 3750 - Catalyst EMI Switch. Cisco 3750 - Catalyst EMI Switch 33 pages. Catalyst 3750 series switches
Également pour Cisco 3750 - Catalyst EMI Switch : Fiche technique (18 pages), Manuels d'installation (47 pages), Faq (10 pages), Bulletin d'information sur les produits (5 pages), Bulletin d'information sur les produits (6 pages), Aperçu du produit (25 pages), Description (1 pages), Fiche technique (23 pages), Bulletin d'information sur les produits (6 pages), Manuel de démarrage (27 pages), Fiche technique (23 pages)

Enter this information in the Network Settings fields:

Step 12

• In the Management Interface (VLAN ID) field, the default is 1. Enter a new VLAN ID

only if you want to change the management interface through which you manage the

switch and to which you assign IP information. The VLAN ID range is 1 to 1001.

• In the IP Address field, enter the IP address of the switch. In the IP Subnet Mask field,

click the drop-down arrow, and select an IP Subnet Mask.

• In the Default Gateway field, enter the IP address for the default gateway (router).

• Enter your password in the Switch Password field. The password can be from 1 to 25

alphanumeric characters, can start with a number, is case sensitive, allows embedded

spaces, but does not allow spaces at the beginning or end. In the Confirm Switch

Password field, enter your password again.

(Optional) You can enter the Optional Settings information now or enter it later by using

Step 13

the device manager interface:

• In the Host Name field, enter a name for the switch. The host name is limited to

31 characters; embedded spaces are not allowed.

• In the System Contact field, enter the name of the person who is responsible for the

switch. In the System Location field, enter the wiring closet, floor, or building where

the switch is located.

• In the Telnet Access field, click Enable if you are going to use Telnet to manage the

switch by using the command-line interface (CLI). If you enable Telnet access, you

must enter a Telnet password.

• In the Telnet Password field, enter a password. The Telnet password can be from

1 to 25 alphanumeric characters, is case sensitive, allows embedded spaces, but does

not allow spaces at the beginning or end. In the Confirm Telnet Password field,

re-enter the Telnet password.

• In the SNMP field, click Enable to enable Simple Network Management Protocol

(SNMP). Enable SNMP only if you plan to manage switches by using

CiscoWorks 2000 or another SNMP-based network-management system.

If you enable SNMP, you must enter a community string in the SNMP Read

Community field, the SNMP Write Community field, or both. SNMP community

strings authenticate access to MIB objects. Embedded spaces are not allowed in

SNMP community strings. When you set the SNMP read community, you can access

SNMP information, but you cannot modify it. When you set the SNMP write

community, you can both access and modify SNMP information.